hello, I noticed that when I execute the `snmpwalk` command on the OID `.1.3.6.1.2.1.31.1.1.1.18` (ifAlias), the result comes back empty. When I execute the OID `.1.3.6.1.2.1.2.2.1.2` (ifDescr), it returns the interface name. For example: eth7. …

I've found a number posts requesting assistance with this, but it appears that no one has had a win. We have multiple sites, all which have multiple WANs configured. In some cases, it's Active/Backup, in others, we are load balancing multiple WANs …

Hello, I have been trying and failing to get SNMP monitoring working for my Sophos XG firewall using PRTG. I have done the following to try and get this working: Enabled the SNMP agent in the firewall config Added the SNMP manager address and…

Is there any way to use SNMP to monitor traffic flow through an IPsec tunnel? I'm successfully capturing port traffic with SNMP but would also like to capture the traffic between our two sites via an IPsec tunnel.

Hello, Can someone help me with my Datto RMM Monitor for Sophos? The policies have been installed way back, but when we replaced the firewall from one of our sites, the Datto Sophos Monitoring is now offline. I am new to both Datto and Sophos community…

Hi; I want to do monitoring from snmp service but I don't want to open snmp service to the all world , I only want to allow snmp to the specific ip adress. for this process; I am going to system -> administration -> snmp and activated the snmp service…

I've tried using the two templates available in the zabbix repository, but without success. Both models do not support OIDs. I manage to communicate my firewall with Zabbix by SNMP, but it is not possible to communicate data because we don't have a template…