Hi Guys, This is our network setup. We have couple of websites and Microsoft Direct Access server sitting on our LAN to access resources from outside .
Currently we have PFSence box and all working without any issue.
With Sophos no luck. I appreciate…
Since upgrading the firmware version, a couple of devices have been blocked from sending traffic between the subnet 192.168.1.0 and 192.168.2.0.
I have set up rules to allow traffic to and from the devices but still unable to ping.
the device in…
Hi There,
i started today with the XG on virtual environment (ESXi7).
I set up a statc route for external additional Network using by a health service.
I add an rule who allows to forward the traffic to this specific network via an internal router…
Hi, We have 2 Wan Ports with load balancing.
We would like for specific websites to go through port WAN2 but all other traffic (other websites) to use the load balancing ratio we have set up.
Sophos XG 135 V19.
I'm having issues getting a static route or SD-WAN route to work on my XGS 116 (19.5 MR1 firmware). I am in the process of replacing aging SonicWall devices with Sophos and it's mostly going ok, except for this issue. The network layout is fairly simple…
Apologies for my poor understanding on routers and English language.
XG210 19.0.0 GA-Build317
We have 3 public IP address ranges from 3 ISPs assigned to 3 WAN ports.
Is it possible to reach our ISP-1's IP address range via ISP-2, ISP-3 WAN when…
While I have been configuring a Sophos Firewall, ran in a strange issue. I setup a SDWAN rule to load balance between 2 ISP links. As soon as the policy is saved, I lost access to the Firewall.
I am able to access Internet through the Firewall and the…
Hi guys..
I'm with problems to propagate networks through BGP with Azure ExpressRoute
The connection is established, but I keep receiving these BFD logs from Azure:
There is any command to solve this?
The firewall is on version
SFOS…
Hello dear community friends! Next, I created vpns tunnels using SD-WAN routes between the DataCenter and the Branch as shown in the image below. Both firewalls are version 19.5.0 GA-Build197
Note: They are currently disabled, as I returned to vpn for…
Hello Everybody
I have a new problem with my installed Sophos Firewall
Firewall XG115 (SFOS 19.0.1 MR-1-Build365)
LAN Subnet:192.168.200.0 Mask:255.255.255.0 GW:192.168.200.1
VLAN 10.20.1.0 Mask:255.255.255.0 GW:10.20.1.1
To be able to configure…
XG86 Firewall v19.0MR1 TLDR: When i enable SD-Wan for a certain zone to use differente Gateway all other rules on that zone is ignored I have 2 Zone and 2 Wan. First LAN zone use ISP1 and ISP2 as a backup For the Second Zone i need ISP2 default and ISP1…
I have 3 sites (A, B, and C).
Site A: 172.16.16.0/24 Site B: 192.168.1.0/24 Site C: 10.23.1.0/24
Site A and B are both Sophos XG firewalls configured with a route based IPSec tunnel interface between each other Site C is remote and is outside our…
Hi,
I'm experiencing a strange issue with the SDWAN routing engine. I have 2 Sophos XG connected via route-based ipsec (xfrm interfaces) and using SDWAN rules for the routing decision.
The XG located at the branch office route traffic, using a SDWAN…
Hi all,
I am in the optics and the reflection to start the project of segmentation of my local network.
i have xg 330 as edge firewall
Si i think about to methods, go with L3 switch for inter-vlan routing or don't make L3 switch and do all the segmentation…
SCENARIO : Sophos firewall IP : 192.168.177.254 Vodafone Router IP : 192.168.80.1 - Internet How do i configure vodafone on sophos in other to get the public IP to use for my VPN connection.
Hey all! I'm looking to schedule SD-WAN routes. For example, to send my traffic down one gateway during working hours but then move to another one for the evenings/weekend. It seems schedules are available elsewhere for rules, but not for SD-WAN. I guess…
We have a separate VLAN set up and working for our Guest Wifi network. Clients (mostly cell phones) receive a DHCP IP in the correct range, are segregated from any other network communication, and can get to the internet fine. What we would now like to…
Hello,
I have this network architecture ,
And my goal is that the VLAN100 (with Network IP : 192.168.123.0/24) to have access on my Server 172.20.24.24
So , I create this Route on my Sophos Firewall ( version XG S3300 firmeware 19.0…
Hi,
I am currently changing our IPSEC VPNs from Cisco ASA to Sophos XGS, but now I am experiencing a strange behaviour regarding the routing. Route-precedence is VPN-Static-SD-WAN.
Currently the ASA is handling the IPSEC tunnels so I created 3 static…
Currently, I'm using the SOPHOS XG firewall in my office There are two ISPs: a primary ISP ( SuperNet ) with a dedicated link of 40Mbps, and a secondary ISP ( Transworld Home Fiber ) with a 100 Mbps shared link, and I want to configure my voice server…
Hey there,
My DHCP IP address from my carrier is 203.xx.xx.xx/16 but the gateway is in a different subnet 100.xx.xx.01.. wacky system, but not one I was really expecting..
The issue I'm running in to is that I'm trying to establish a backup IPSec…
Hello Everyone,
one of our customers has a phone system (Panasonic KX-NS700) that uses multicast to synchronize the Cell-Stations (KX-NS0154). The Cell-Stations (DECT) use PTP for synchronisation.There is one Master and several Slave-Stations. Although…
i have XG firewalls located in china and sometimes the latency of some links to sophos getting to slow so i dont get a resonse in time for example for live protetcionn right now im trying to setup a SD WAN for all sophos services, but that it work well…
Good morning everyone, I configured the BGP over RBVPN between our office and the 2 connectivity present at one of our customers (fiber and radio link), the connection is made via the prepend AS also tried with LOCAL PREF AND MED, if I try to switch off…