Hi,
I have just configured a XG230 and a SD-RED60 to be in a bridge setup.
This bridged setup has stopped the AP on the SD-RED60 from being sensed by the XG230.
I have exhausted everything I can think off but it isn't showing up in the lists of…
Buenas tardes,
Estoy sincronizando un SD-RED 15 W contra un Sophos XG 310 pero me permite la sincronización más no me da DHCP.
Las pruebas que se han realizado son las siguientes:
1. Se sincroniza y funciona la conectividad.
2. Se establece la…
I have RED 20, it was configured and working fine. it is with static ip. after restart it is shwoing offline on XG side. and RED 20 is power up but it is not giving ip address to local lan. please advise how to fix it?
Hi
I try to setup VLANs behind a RED 20 device for the branch office, which is connected to a XG firewall. The RED device is in zone "RED" and the HQ in "LAN".
On the XG firewall I added a VLAN-interface (ID 100) for the RED-interface.
The IPs for…
Liebes Forum,
ich möchte gerne über eine vorhandene XG 125 und eine RED 60 zwei Netzwerke durchschieben.
Was ist bisher konfiguriert?
Sophos XG 135 mit zwei Netzen Port 1 - Netz 1 - Büronetz 192.168.10.1 /24 Port 3 -Netz 2 - TK-Netz 192.168.20.1…
I need to deploy an XG at the new site with a VPN tunnel back to the client's head office, but the remote site does not have a static (or even it's own public) IP address. Traffic goes through a NAT pool at the ISP. With the SG you could configure an…
Hi,
I tried to set up a network connection between a Sophos XG firewall and a Sophos Red.
I follow up the below guides to set up the Red connection:
https://support.sophos.com/support/s/article/KB-000036699?language=en_US
https://community.sophos…
Hello,
hello all. we have been trying to install a sophos red 20 including dhcp for some time now. the red has been configured and also reaches the internal network. However, as soon as a dhcp request is sent from a client behind the RED, this request…
I have a scenario with an SD-RED20 connected to an XG210, through a Split tunnel. The question is whether even though I have a Split Tunnel and in a moment the service of the XG210 device is lost or it just shuts down, does the SD-RED device also lose…
Hello,
We have a PBX inside the network 10.20.0.x and we need to access it from two other different networks (192.168.1.x and 172.14.0.x).
We have two RED15 devices, 192.168.1.1 and 172.14.0.1 so we can connect to the PBX on the 10.20.0.x. Both…
Hi Good Day
it is possible that sophos red can be connected in this network diagram
ISP --> PEPLINK---> SOPHOS XG
note: peplink is not in DROP IN MODE
thank for the help..
Hello, we have a problem with the transmission of the voice on our IP telephones between the XG and the SD-RED 20. The connection can be established (it rings and you can pick up the receiver), but nothing can be heard. The RED is located in the network…
We have a need to allow multiple multicast source devices to have their multicast packets sent across to the branch office through RED device and vice versa. I did a bunch of research but haven't found anything specific to what I am trying to do. Basically…
Hi, we are currently migrating some RED 15w devices from Sophos SG to Sophos XG.
Our setup is follows:
- Each RED Device is in a seperate /28 subnet
- On REDs with split tunnel I configured the magic Wifi IP 1.2.3.4
- A few REDs tunnel all neworks…
Hello,
I have two xg 210 in A/P HA (18mr4) and two branch offices with red60
LocalityA - 2x xg210 HA (ISP 100/100Mbps) FileserverA
- utilization is about 50% during working hours and 10% out of working hours
LocalityB - RED60 (ISP 100/100Mbps…
We have replaced an XG firewall due to hardware failure and restored the configuration from backup
All is running fine except for a RED that is not connecting anymore.
do we need to disable the RED service and enable it again to let it working ? …
Hi I have one XG 210 v 18 MR 5 and one RED- 60 whit built in WiFi card . Randomly the DHCP on the RED cable connected computers stops working . WiFi DHCP still works . When this happens, we need to restart the RED box . Can't find anything in the logs…
i want to deploy sophos red 20 at one of my remote site. at that site isp is providing internet but with static ip. my question is that how can i deploy sophos red 20 if i am with static ip from isp. please advise.
Hallo zusammen,
ich versuche ein Telefon der TK-Anlage aus dem Hautpnetz (XG 210) hinter der RED zu betreiben.
Folgender Aufbau ist vorhanden.
Die RED registriert sich an der XG.
Das Telefon bekommt keine Verbindung zur TK-Anlage.
Muss ich…
Hello,
Pretty much out of the blue I can't get my RED15's to work in Transparent/Split mode against 18.0.5 MR-5.
By work I mean accessing resources on the LAN behind the XG firewall.
I can't recall making any changes that will have any influence…
Hello,
I'm looking to install a Red device to establish a VPN between 2x sites so a NAS at site2 can be accessed by devices at site1. But I still need other devices at site2 connected to the ISP supplied modem to still be able to access the NAS too…
Hi all,
Running 18.0.5 MR-5 I cannot make SD-RED 20 do SPLIT tunnelling, is this still a bug like 4 months aho or is the bug "me"? :-)
It's setup with split now, it's online, traffic flows, but is originating from the XG like UNIFIED mode.
Hi,
I have seen that several discussions have been on the subject... but I can't find the solution....
My XG115 is set to 192.168.178.1, DHCP 192.168.100-254. The RED 20 is set to 192.168.179.1, DHCP 192.168.179.100-254. Rules are set: from the source…
Hello, I have connection between two sites (Head Office and Branch Office) in the HeadOffice i have an XG Firewall connecting to the Branch Office through RED, i can ping the RED from the XG Firewall, but cannot ping the hosts behind the RED. i can also…
Hi
I have an XG 210 at the main office and SD-RED 60 at a remote site.
I would like to have data (2) and VoIP (10) VLANs routing to the main office LAN.
I have setup the RED without VLANs in switch mode and all works fine, but when I change to VLANS…