First, thank you, 2nd, sorry ;-)
I just got my XGS4500 setup, very basic default setups.
We use Unifi switches, we are migrating from a Meraki.
We have all our Wifi working, all the VLANs and whatnot - but our printers (for whatever reason…
Hope someone can help figure out what I am missing. I am pretty sure the issue is on the Sophos XG. I am setting up several VLANS on my Cisco 9500 L3 switch and the issue I am having is I cannot get passed the gateway when trying to access another VLAN…
We were doing DHCP via Windows Server but decided to use Sophos XGS.
DHCP to assign VLAN to Polycom phones via OPTION 128 String VLAN-A=20; - NOTE the ; (semicolon) MUST be at the end of the string for it to work with Polycom. XGS will not allow me…
I have 3 VLANS, 1 for CCTV, 1 for wifi controller, and the other for IP phones.
data network - port 1 192.168.0.0/24
port1.12 - 192.168.2.0/24 - wifi. (VLAN)
port1.13 - 192.168.1.0/24 - CCTV (VLAN)
We want to manage the CCTV and the access…
Hello
I am trying my head around strange VLAN issues when XG is virtualized.
The setup is as follows -
ESXi has VLANS created. XG has two ports - Lan and Wan.
Lan is on 4095, Wan is on different switch.
XG Lan has multiple VLANS created (reflecting…
hello ,
I am encountering the following problem:
to simplify
I have vlan A and vlan B
Both have active dhcp server in sophos. Both work normally. However, if I set an ip/mac for a device in vlan A, sophos, vlan B does not deliver any more IP for this…
Hi all,
i installed Sophos on hyper-v (vm) with 3 NIC:
- NIC-A “LAN” (physical nic on server)
- NIC-B “WAN” (physical nic on server)
- NIC-C “LAN” (private virtual switch hyper-v)
I’ve created Bridge with NIC-A and NIC-C, with "enable routing…
Good day Members, I trust you are well. We are trying to setup a guest Wi-Fi with Sophos and Unifi. We have it currently working but with the DHCP server on the DC, We would like to move the Guest Wi-Fi DHCP to the Sophos XG. Main issue is device are…
XG210, SFOS 19.5.2 MR-2-Build624 So, I have two VLANs, VLAN 70 - 192.168.70.0/28 and VLAN 100 - 10.0.0.0/24. DHCP server is on VLAN100, I want to relay DHCP requests from VLAN70 to VLAN100 for service. I have a relay set up like so:
Name
…
Hi
I am using XG-115 as my firewall and already got number of rules. I also have a couple of VLANs. I followed the below guidance given by Sophos tech support team.
The rule works well with individual hosts. but when I replace the individual host…
I have a small problem, I have a mikrotik router set up wlan10 (10.10.10.1/24) on port 2 everything works, I connect directly to the router, I have access to the network via vlan10, and when I connect sophos home (in bridge mode), I have an address assigned…
i have dns domain server 10.0.0.1 mask 255.0.0.0 gateway 10.0.0.2 & and ip range is 10.0.0.1 to 10.0.0.254 but now i want to give different ip range to different department like 10.0.1.1 to 10.0.1.254 to support department and 10.0.2.1 to 10.0.2.254 for…
Hi,
Sample: configured sophos XG135 VLAN1 to go through port 1 of the firewall , how do i set it to use port 3 and 4 on switch for VLAN1.
VLAN1 goes though port 1 on firewall then port 3 and 4 on the switch connected .
Port 1 part is done, how…
I just cannot figure this out now. Been trying this for a day and desperately need your advice on this.
I am trying to build a simple separated (isolated) VLAN from Ubiquiti Unifi AP Network to Internet route: Unifi AP -> Unifi Switch -> Sophos XG.…
Hello,
I created a VLAN for my WAN interface. I see the IP in my FritzBox but the Gateway in the Sophos XG Home is offline. The ping check under "diagnostic" failed, too.
Fritzbox
Network Interfaces
Gateway
Good day everyone,
I have been asked to update our network so our data demands can be met. Currently, we run a conventional flat network and our Sophos XG is routing all the traffic. THru my research I think the best solution is to design the network…
I followed this helfull guide:
Sophos Firewall: Interface / VLAN Migration via XML Import/Export
I am facing a migration from SG (UTM) to XGS (SFOS) with hundrets of VLANs an DHCP-Server.
Sophos Migration Support converted the config of the SG and…
Currently, I created Vlans for my each SSID of my Unifi APs. I have 4 APs, all connected to my TP-Link poe switch, which is Vlan aware also. The poe switch is plugged to my Cisco switch e.g. port 10 (Vlan aware). All other desktops (not in Vlans), NAS…
Hi all!
Quick question regarding XGS 126: MTU is a property of the physical interface. If I want to reduce the MTU for a VLAN I have to do it on the physical interface.
By adjusting MTU value I seem to lose the VLAN interface and the associated dependencies…
I have a problem where I am unable to ping google and it somehow seems as the firewall is missing a route back to my client. My client is inside a VLAN (172.16.87.99) and from the traffic below I can see that it correctly routes to the gateway address…
Hello,
i have a problem with the internet connection on physical port WAN with additional vlan (zone LAN). I tried to change the physical port to an dummy ip and zone DMZ and create two vlans 1 (WAN) and 40 (LAN). My router recognizes the IP address…
Hi,
We have just started using Sophos FW and having some difficulties creating Rules.
We have two vLANs vLAN10 and vLAN20. We need to allow vLAN10 to have full access to the internet whereas vLAN20 should have a whitelist, i.e. access to few websites…
Hi,
I'm new with this equipments, i'm trying to configure VLANS between two equipments (SOPHOS -» Switch)
SOPHOS:
- WAN - DHCP from ISP router
- LAN PORT1
IP: 192.168.100.1/24 - ZONE LAN
1.10 - VLAN 10 - 192.168.10.1/24 - PORT 1 - ZONE…