Hello all,
I have two networks in our LAN zone:
10.0.180.0/24
10.2.180.0/24
Here is the interface config:
We have a LAN-to-LAN rule that I would assume should allow traffic between hosts on either network:
From either network…
Hi,
we discovered today that it's not possible to create a Hotspot (for a Wifi) if the VLAN interface is behind a RED device. In our case RED60 but this should apply to all RED types.
The interface "hardware" is not shown on XG Hotspot creation…
Hi, i have a request for all
Sometimes i have my interface (Port 1) who Down/UP ==> Sophos ID 17813
My Port 1
Under this interface , i have 3 VLAN
Conf VLAN (all vlan are the same configuration)
When this appears on night,…
Hi everyone,
I have two IoT devices that need connected both wireless and wired on the same network.
Wireless and wired (connected to a dedicated port of the FW via a switch) clients must have the same IP adress range (so the same DHCP).
How I could…
Hello i just purchased this firewall and have the following setup
I have 3 dhcp scopes:
VLAN_500_SCOPE - 192.168.10.100 - 192.168.10.200
VLAN_600_SCOPE - 192.168.20.100 - 192.168.20.200
WFIF_SCOPE - 192.168.30.100 - 192.168.30.200
…
Hi,
I managed to get two WLAN networks working on the Sophos XG using our existing Unify AP's.
Port4, zone wifi, static gateway address in the LAN range, LAN Relay
Port4.120 WifiGuest, DHCP server with IP address 192.168.120.x
Port4.121 Wifi,…
Hallo ,
Ich habe folgendes Problem wo ich gerade verzweifel:
Wir setzen Macmon als automated NAC ein. Wir haben derzeit eine UTM 450 mit 22 angeschlossenen RED15W Filialen.
Nun soll die Sophos mit den RED15W und AP55 Wlan bereitstellen, die NAC…
Hello Chris
I see two options here to make things better.
a) community.sophos.com/.../123881
b) As MTU on XG sep zone is fixed to 1450, you might change MSS on your WAN Interface to 1410 (or even lower) using the "Override MSS" Option in the advanced…