Hi all, can someone provide a hint, how to access a device where all LAN-Interfaces are "tagged" and "LAG"-ports? I've restored a migrated config and now the only untagged port is the WAN-port (can#t ping or access these port) I am able to access…

Hello, So I have a weird scenario and I need second opinion. We have two firewalls Active Passive and two switched Active Active The first switch was configured to connect to the primary firewall on a port F4 and this port has vlan on it,…

Hi all, Is it possible to got interface- & error details for a LACP-connection? Thx Dirk

Update to LAG not working unless you specify interface speed Using XGS4500 on 20.0.0 GA-Build22 with XSAZTCHF4 "Sophos FleXi Port Modul 4 port 10GbE SFP+" LACP bonding was not working on PortsA1-A4 unless specifying 10G Interface Speed manually, disabling…

Hi, I would like to remove an interface of a LAG (HA AP Setup with 2 Nodes, XG310 (SFOS 19.5.0 ). I removed port8, clicked save, then the XG rebooted and the 2nd node became active. There the interface was still present. A renewed reboot back to node…

LAN LAGG (NON LACP) Active/Back-up Stops working after 5mins. I have to unplug one of the links for it to start working again. Until i unplug one of the links, can't ping the XG, get online and the SOPHOS Wifi stops working..... Basically the LAN…

We have an Aruba 2930M switch with 2 SFP+ ports as a LACP trunk connected to a Sophos XGS 4300 with 2 SFP+ ports combined as a LAG. We have several VLAN interfaces setup. I am unable to pass any traffic through to the firewall. If I break up the LAG and…

Hello, I converted a XG firewall from appliance to virtual and I want to remove old lag interfaces. I was able to delete lag0 but I am not able to delete lag1. Lag1 interface got no sub-interfaces, only two attached ports: Error message is…