RE: RED15w Access Point not showing up as pending access point
Hi Christian
I've got exactly the same Issue/ Problem which you described.
The only difference: If I delete the Red15w, connect it to another UTM (which changes the unlock code), delete it there and connect it to the first UTM again (which again changes…
Zentrale Übersicht / Verwaltung
Hallo zusammen,
wir haben mittlerweile über 10 Hardware Appliances und sind gerade dabei die 6. Red einzurichten.
Dabei ist uns einmal mehr aufgefallen das eine Zentrale Übersicht über den Status aller Verwalteten Geräte so manches Erleichtern würde…
RED 50 in Split Mode how do you process WEB Protection Rules on the ADSL Link
Hi All
I have a UTM 9.4 and RED 50.
I sold this based on the documentation that I read saying that you could add Web Protection Rules.
When in this mode I don't see an Interface to add the Web Protection Rules.
So how do you go about protecting…
RED15w (Standard/Split mode) Wifi Access guest only subnet no access to anything but the internet
Hello,
I'm wanting to setup a RED 15w in Standard/split mode back to my UTM 9 for my remote users at our remote terminal sites but have the Wifi setup for only guest access to the internet. We are a trucking company and have drivers who want internet…
RED15 UDP 3410
Right now my company just moved to a new UTM and we upgraded a few REDs to the RED15rev1. I read in the documentation that you needed to allow UDP3410 so it can communicate properly. Would we need just create a service definition for this port and allow…
RED als Open DNS resolver?
Hallo zusammen! Wir haben einen Teil eines Kundenstandortes per RED an unser RZ angebunden. Dort habe ich momentan das Problem, dass (anscheinend) die RED als open recursive DNS Resolver fungiert.
Wird der Server hinter der RED vom Netzwerk getrennt…
RED at China
Hi to everyone,
we have one RED installed at an China company that after some days it stopped the connection with the UTM. We asked to the technicians to send us a video of the leds sequence on the RED and the sequence stops on the last led (tunnel…
Not able to ping Internal DNS Server through Red 50 Tunnel
I have a Red 50 set up for standard / split and I have the DHCP set for a different subnet 172.17.44.0/24 than my main subnet of 172.17.43.0/24. The gateway and dns for the DHCP group are the Sophos Red IP Address 172.17.44.254
I am able to connect…
Remote Access VPN
We have implemented RED devices on a couple of branch offices .
Users of those offices need to access some servers from outside , previously they opened a VPN connection directly to the branch office ,
Is this still possible with RED or do they have…
ipseipsVPN tunnel between two branch sites (one of which has a RED)?
So, I have been given the task to transfer data between two of our branch sites.
Currently, our company network uses a star-like network arrangement with our branch sites connected to HQ through VPN tunnels - network traffic can flow between a given…
Using internal DNS (AD) for RED connected clients.
Greetings:
I have a RED 15 connected to an SG135w. Most everything seems to be working ok.
Remote client can surf internet. Connect to Remote Desktops. Avaya IP 1608-I phone connects with no modifications from "internal" config. required.
The…
Dropped packages and Firewall violations even though Allow All rule
Hey everyone,
we have an SG 105 on the main branch, network is 192.168.42.x and a RED 15 on a subsidiary branch which is 192.168.9.x
The RED serves fine DHCP on 192.168.9.128 until 254.
Being on the remote subsidiary, I am able to for example ping…
RE: RED down and up, Interface bleibt down
Hallo zusammen,
habt Ihr das Problem mit den REDs noch?
Bei uns SG330 HA / RED 15 - FW 9.402-7 tritt genau dieses Problem auf. Nach einen DSL Reconnect auf der RED Seite wird die RED zwar als Online angezeigt es geht aber kein Traffic über den Tunnel…
Setting up Wifi on a RED 15w connected to a SG-105w
How am I suppodes to setup/enable the WiFi on a RED 15w connected to a SG-105w? The W-Lan on this remote UTM is already up and working.
In the Admin interface, I can see the interface wlan0 (which is enabled, working and bridged to eth0); as well as…
How can I reset a RED 15 device back to factory defaults
Is there any way to reset the device without recovering the utm with a recent backup file, because I reconfigured the utm manually with different configuration.
Routing across RED link (UTM as RED) not working after update to 9.356
We have a client with two sites. The main site has several subnets, on different interfaces of the UTM. The remote site has one subnet. Communications between the sites was facilitated by RED link (UTM as RED). This has been working perfectly for some…
Slow VPN data speeds between Red 15w and UTM SG230
Hi all,
Apologies if this has already been covered, but I could not find a definitive answer.
We have an SG230 at the Corporate Head Office and a number of RED 15w in staff member's homes.
Our SG230's primary WAN link is a 100Mbit/sec in both…
Do transparent / split tunnels act as a DHCP server?
We have some IP phones at a remote site which has limited bandwidth (currently connected to a RED50 using a standard / split tunnel)
I am trying to setup a QOS rule so the phones always get a reserved chunk of the bandwidth as the site often maxes…
How to get the IPs of (all) connected REDs via command-line?
Hi
is there any command to get the IPs of the connected REDs via command-line? I already tried
cc get red
but it only shows the internal name of the REDs, certs and so on, but no IPs.
Regards Rolf
IPv6 DHCP in an UTM RED-Server/Client network
In order to migrate our internal network to a dual-stack configuration, we would need to provide v6 addresses via DHCP to all remote sites.
Each site is using a Sophos UTM 9.4 gateway, all connected via RED Client/Server channels to our 2 central sites…
RE: RED weisst keine IP-Adresse per DHCP zu
Habe ein identisches Problem hier aber mit einer Red50.
Nach Löschen und Neuanlage der Red50 geht es ganz normal.....bis zum nächsten Stromausfall.
Vielleicht hat einer einen Tipp. Dem Hinweis vom Support auf die 9.4er Version upzudaten und zu hoffen…
RE: RED down and up, Interface bleibt down
Hallo zusammen,
wir haben das gleiche Problem. RED 15 hinter einer FritzBox 3xxx und dynamischer öffentlicher IP-Vergabe, Verbindung zu einer UTM120 mit Firmware 9.355-1 mit fester IP. Nach dem DSL-Reconnect der FritzBox sind keine Geräte des RED…
Workaround for dealing with inconsistent upload speeds
We have 3 locations - one hosts the UTM9 and two have RED50 devices linking our sites together for voice and data. All sites have download/upload speeds of 100/20 mbps. Because everything routes through the UTM, however, the reality is that our two RED…
RED 15 Internet USB Compatibility
We are currently using the SOPHOS UTM 9 and the RED 15s to set up a VPN across multiple sites. However, one site can inly have a wireless USB connection, and we need to know which devices are compatible with the RED 15s.
Are there any? Because so far…
RED down and up, Interface bleibt down
Hallo wir haben diverse REDs an einer redundanten SG430. Ich pinge an das Interface mit der RED aus dem entfernten LAN und an eine Maschine dahinter.
Der Effekt: Ich schalte das RED down, beide Pings gehen weg. Ich schalte das RED wieder up, kein Ping…