Hello everyone,
We are currently using the SSL VPN to connect our employees from the home office. As our Internet line was very slow, we have now upgraded to a faster line in addition to the previous one. The two lines will run in parallel for a while…
I know the system automatically backs up the config before applying firmware. I wish Sophos would add a hotkey or a console command that would be advertised after logging in that would list out all the backups on disk and let you pick to restore. If this…
I switched ISP's. I have a block of statics so I reconfigured the Sophos UTM by simply editing the IP address of the external interface and the IP's listed on the Additional Addresses tab. Those are the only settings that I changed.
Everything works…
Hallo zusammen,
wir haben verschiedene Sophos UTM an verschiedenen Stellen im Einsatz.
ich würde bei der primären von uns gerne über einen Link oder ein Script o.ä. vereinfacht beim Aufruf die Arp Table sehen, bzw. die IP und MAC Zuordnung. Via…
Apologies if this topic is covered here elsewhere. A quick search did not find a solution.
We have the following equipment:
Endpoint
LAN: 10.0.0.40
GW: 10.0.0.1
Sophos UTM
LAN (eth0): 10.0.0.1 /24
WAN (eth1): 100.100.100.2
Private…
Hallo,
ist es moeglich bei einer virtualisierten (VMware ESXi) Sophos UTM 9 eine 2. IP in Richtung WAN einzurichten wenn der Provider vorraussetzt das alle erreichbaren IP-Adressen mit einer bestimmten und unterschiedlichen MAC-Adresse konfiguriert…
We have have a primary and secondary ISP connection at the office and configured uplink monitoring to automatically switch between them. In general the primary ISP line has been working well for several months (since Jan 2021) but during the last days…
I wanted to install a HA device additional to the existing SG230 in one of our subsidiaries.
We had networking problems so I did a tcpdump on several interfaces and so internal traffic on outside interface and vice versa.
Result is (and this is…
Hi Leute,
Ich habe ein SD-RED 60 Device im VLAN-Mode (ich brauche 4 VLANs am Remote-Standort). Dieses läuft einfach an einem klassichen NAT-Router via V-DSL (z.B. FritzBox - kein exposed Host).
Die SD-RED 60 ist wie folg eingerichtet (standard/unified…
Grundinfo: SG125w (FullGuard) mit 4 APs lokal, 1x RED15w (funktioniert), 1x SD-RED 60 (funktioniert nicht), 1x APX-320 hinter SD-RED60 (funktioniert auch nicht)
Die Grundfirewall läuft seit 3 Jahre ohne Probleme durch und wurde immer wieder um RED-Devices…
Hi,
momentan läuft der intern smtpd auf der UTM auf allen interfaces. Das möchte ich gerne beschränken auf LAN und eben VPN, sprich Site2-Site VPN. Bei der Konfiguration der SMTP Interfaces kann ich aber das Site2-Site nicht sehen. Ist ja auch logisch…
Hallo,
wir haben unregelmäßig das Problem, dass eine zusätzliche Adresse am WAN Interface Ihren Dienst quittiert.
Es handelt sich um eine SG125 mit 9.705-3.
Wie folgt konfiguriert:
Ping ist freigeschaltet, geht im normal Zustand von intern wie…
Hi, Tony here (sorry the temporary maintenance seems to have created me a new user and not offering me a login!)
I am trying to add an additional IP range to my Sophos UTM. 9.413-4 (Virtual appliance)
I have 6 physical interfaces. 2 of them are…
We are adding 2 WAN connections next week I have reviewed as much documentation as I can but I cannot determine the best and correct configuration to achieve this. both new WAN lines are working 1st mainline microwave and the 2nd fiber we want to creat…
We are adding 2 WAN connections next week I have reviewed as much documentation as I can but I cannot determine the best and correct configuration to achieve this. both new WAN lines are working 1st mainline microwave and the 2nd fiber we want to creat…
Hallo,
wir haben auf unserer UTM9 ( 9.705-3 ) zwei DMZ Interfaces mit jeweils anderen ISP´s.
DMZ1 geht über ISP1, DMZ2 geht über ISP2.
Nun wollen wir aus dem DMZ1 Traffic an eine externe IP die am ISP2 per NAT an die DMZ2 aufrufen.
Leider versucht…
Dear Sophos specialists,
I know your support forum for several years and i always found here solution for my problems. But in this time, after few days of trying, reading topics and thinking i cannot solve current problem on my own.
Problem:
I have…
I have had the following issue occasionally over the years, and am surprised it hasn't been brought up / fixed before. Unless there's a simple workaround I'm missing.
A (simplified) example:
- Standard(ish) UTM install, one uplink, two internal subnets…
I am trying to configure VLANs for my WiFi and I am having problems and I am not sure if its the WiFi system, the HP switch or the Sophos SG135w UTM 9.
I currently have 6 AP's to cover the whole site, 3 x UniFi AP and 3 x UniFi AP-Pro they end up in…
Hello,
We recently had to move buildings quickly and as a result our ISP isn’t in place yet. As a work around we’re using hotspot to a windows 7 box, configured ICS and then sharing that connection to the clients and VPN to connect to resources. However…
I'm using the UTM 9 SSL Remote Access VPN. I'd like to be able to set a Network Group consisting of my internal interface and one of my external faces as the "Interface Address" for my VPN. Under Remote Access > SSL > Settings > Interface Address, I'm…
Good afternoon
We currently have a UTM 9 setup to connect to the WAN port on RED 50 which supplies with DHCP, DNS etc..
Now, we want to have port 2 on RED 50 tagged with vlan 72. No problem there pretty straightforward.
My question is how do we…
Has anyone had to overcome Asymmetric Routing in your LAN similar to these diagrams? There is alot of serial communication traffic being converted to ip traffic then needs to route to a server on the remote lan. 10.141.12.1 uses 10.141.12.86 as the gateway…