Hi, I have several web servers running behind a single Sophos UTM, with two interface: - eth0 > external (x.x.x.7/26) with default GW (x.x.x.1) > Additional addresses > x.x.x.8/26 > x.x.x.9/26 > x.x.x.10/26 > etc - eth1 > internal (10…

Hi, I need to set up a way to route specific traffic from one server out through or to show as an additional public address that we have set up but cannot seem to figure out where to set it. It always seems to show as the main IP address of the interface…

Hello Everyone, a customer of ours asked us a question about giving a Power-User a seperate DSL-Line with a static IP-Address for his home-office. So here is my question: Is it possible to give one single user an ssl-vpn profile that connects…

Hello Sophos community, I am trying to configure a source NAT for an internal server. I want the server to be known on the outside as one of my additional addresses, like so: LAN_SRV --> Using Any Service --> Going anywhere Translate source…

Hi all, this is my first time on the forums so be patient. I am currently investigating the "Server Load Balancing" feature on UTM 9.4. From what I understand when configuring the Virtual Server you need to specify an IP address on an interface. Let…

I am new to this and just finding my way around setting up utm/firewalls i have a 2 firewall setup an internal sophos utm 9 ffirewall and an external firewall The internal firewall sophos utm 9 is setup where all computers and mobile devices are behind…

Hi folks, I'm running a SG 115 W with latest sw release. On WAN NIC I've been assigned a /28 subnet from my ISP. Let's name the net AA.BB.CC.DD/28. From this /28 I'like to use 3 IP addresse for the UTM itself, i.e. one as "default" gateway for general…

Hi, We have SG310 with latest updates installed. we have 5 public IP's from our ISP"X" and another 5 from ISP"Y", what i want to have is: Our production network (eth0) will get out through (eth1) ISP"X" with a public IP(1) Our Mail Exchange server…

UTM 9.3 Software version Onboard NIC - WAN Dual NIC Card - Internal Networks. I have just set up and activated the second internal network. I want to keep the two segmented and understood this was by default. However, when I tracert a device on network…

Posting this question again on the new forum.. Here is the link to the old: https://www.astaro.org/gateway-products/network-protection-firewall-nat-qos-ips/59993-additional-address-stops-responding.html Still battling this problem. Wondering if it is…