• Physical interface Not working on XG135

    Boaz Nyamukuvhengu
    Boaz Nyamukuvhengu
    LAN port 1 and the rest of the other 7 ports on xg135 not working. After turning the device on the interface ports only flicks green and yellow lights at first then go off. I have tried the following: 1. Hard reset on the device 2. Factory reset…
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • Firewall Temp

    Tharindu Premarathne
    Tharindu Premarathne
    Hi, Is there any way to check the Sophos XGS firewall temp? Firmware V19.5.MR1 TIA
    • Answered
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • Externes Interface offline bei PS5 Update

    mm_sophos2022
    mm_sophos2022
    Ich habe eine XG (Virtual Appliance) im Home Office laufen. Mein Internetanbieter ist von Magenta über Kabel mit 500/50. Wenn ich mit der PS5 ein Update eines Spieles oder der Systemsoftware mache, geht das externe Interface auf offline, bis ich das…
    • over 1 year ago
    • Sophos Firewall
    • German Forum
  • Install Sophos OS in Proxmox

    Diogo Moreira
    Diogo Moreira
    It is possible to install Sophos Firewall OS in Proxmox with the ISO image, or is just possible with de KVM image?
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • Harddisk Problems with different models

    xg-andy
    xg-andy
    Hey guys, we have trouble with several models (f.e. XGS 3300 and XGS 4500) and the Harddisks. Mostly when i upgrade the clusters the problem comes in front. When the devices are running we expect the logging/reports is not working, firewalling…
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • gridscale VM boots in failsafe mode

    Julian Koch
    Julian Koch
    Hi everyone, I am currently trying to get a Sophos Firewall working as a VM in gridscale. It boots up in failsafe mode however, saying it doesn't have any interfaces. I have assigned interfaces to the VM. How do I add an interface via CLI or configure…
    • Answered
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • Rack Mount Kit for Sophos XGS 126

    Don Paul
    Don Paul
    Has anyone ran into the Rack mount kit for the XGS 126 holes not lining up. If you screw in the front, the rear 2 do not line up. If you do the opposite, the front hole will not line up. See attached picture as an example I double checked and we do…
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • Sophos XG 330 Lüfter drehen immer wieder hoch

    Matthias Botlik
    Matthias Botlik
    Hallo Community, ich habe vor ein paar Tagen eine alte Sophos SG 230 gehen eine XG 330 ersetzt (SFVH) und habe nun das Problem, dass die Lüfter ohne erkennbaren Grund immer wieder hochdrehen. Das passiert mehrmals pro Minute und kannte ich von meiner…
    • Answered
    • over 1 year ago
    • Sophos Firewall
    • German Forum
  • ADAPTER TECH ATS036T-W120V - UK

    MikeyS
    MikeyS
    Is there anyway of getting the UK plug connector for the ADAPTER TECH ATS036T-W120V PSU?
    • Answered
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • Sophos XG - Can I set the NTP poll time?

    John Hanson
    John Hanson
    I'm running Sophos XG in a VM on my QNAP. When there is a power failure, my QNAP suspends my VMs and shuts down. Upon reboot, it resumes all the VMS and uses virtio-serial to sync time. Since Sophos XG doesn't have support, the time is off, which doesn…
    • Answered
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • Modules & interfaces'

    Leonardo Mota
    Leonardo Mota
    Hello! I was wondering if Sophos would sell those modules ( interfaces) when someone buys a firewall. 1 - 25 Gbps SFP28 2 - 40 gps qsfp + Only asking because i Could not find it in sophos firewall datasheet. (modules) If someone could help- me.…
    • Answered
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • Azure PAYG Licensing

    Brandon Dale
    Brandon Dale
    If I run the XG Firewall in azure Microsoft Azure Marketplace as PAYG licensing, am I billed for the hourly cost of of the PAYG license if the Sophos VM is in a stopped state? I understand in a stopped state i am billed for the azure vm cost, in a stopped…
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • Sophos XGS3300 FIREWALL

    Leonardo Mota
    Leonardo Mota
    Hello, I'm founding difficulties determining if the XGS 3300 firewall can support a 2gbps throughput in a HA cluster with 2 equipments. Can someone help me? Also if it has a firewall throughput of at least 37 gbps; a ips throughtput of at least 13 gbps…
    • Answered
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • SG135 Rev3 PSU SKU

    MikeyS
    MikeyS
    Does anyone have the SG135 Rev3 PSU SKU number for a UK PSU? Looking to potentially purchase one if not too expensive.
    • Answered
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • SFOS 19.5.2 MR-2-Build624 crashing

    twister5800
    twister5800
    Hi all, Since SFOS 19.5.2 MR-2-Build624 we now have 3 customers so far, some with HA setup and others with stand alone, that the firewall suddenly stops and all the network interfaces are off. The LCD panel on the front shows fw status, but none…
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • UPS interface for monitoring power on XGS firewalls

    Mark Poore
    Mark Poore
    the UTM had a way to monitor UPS. is this no longer available in XGS?
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • XGS 3300 "Bus error (core dumped)"

    Bart van der Horst
    Bart van der Horst
    Customer has a XGS 3300 in HA, last week we tried to update to new firmware 19.5.2 (installed is 19.5.1) and that didn't work. After investigation we discovered the Auxiliary unit didn't response to anything than a hard reboot. After the hard reboot…
    • Answered
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • XG SW HCL List und Lizenzlimitierung

    SR-M
    SR-M
    Guten Tag ins Forum. Gibt es eine Auflistung der unterstützten Hardware der aktuellen SFOS 19.5 oder generell der Version 19? Vergleichbar einer Hardware Compatibility List, gerade was die unterstützten Netzwerkkarten angeht, dort hatte ich in der…
    • over 1 year ago
    • Sophos Firewall
    • German Forum
  • Sophos Hardware und GPON SFP

    Christos Vassiliou
    Christos Vassiliou
    Hallo, hat jemand seine Sophos Hardware mit GPON SFP am laufen? wenn ja, wie hast du die ONT Kennung und ONT Installationskennung eingetragen? Welchen SFP Typ hast du genommen? Und am besten wenn es Vodafone war. Danke!
    • Answered
    • over 2 years ago
    • Sophos Firewall
    • German Forum
  • Welche Produkte sind sinnvoll?

    gian duri calonder
    gian duri calonder
    Hallo zusammen Wir möchten gerne auf eine Leistungsstärkere Sophos Geräte umstelgen. Der Partner der die letztes Mal gekauft hat, sagte uns eine Firewall XG 126 oder höher wäre gut aufgrund unserer Nutzung. An den aussenstandorten haben wir jetzt…
    • over 1 year ago
    • Sophos Firewall
    • German Forum
  • Status: Kritisch - Hostverbindung und -betriebszustand

    Bernett22
    Bernett22
    Hallo Forum, ich habe mal eine Frage. Wir haben VMware ESXi 6.7 U3 im Einsatz und bei einem Host im VCenter wird nach jedem Reboot folgende Meldung angezeigt: Hostverbindung und -betriebszustand Registrierung/Aufheben der Registrierung von Drittanbieter…
    • over 2 years ago
    • Sophos Firewall
    • German Forum
  • XG Home ISO lässt sich auf aktueller Intel Hardware nicht installieren

    Alphavil8200
    Alphavil8200
    Hallo zusammen, mein Plan war es auf einer neueren Hardware die XG in der Home Edition aufzusetzen. Dies schlägt allerdings fehl, dabei ist es egal ob ich es per Stick, CD, DVD oder sonst was versuche. Auch sämtliche Bios-Einstellungen habe ich versucht…
    • over 2 years ago
    • Sophos Firewall
    • German Forum
  • HyperV setup help

    Partha Goswami
    Partha Goswami
    I have setup XG firewall on HyperV all is good, but when I am doing MTR to WAN IP i am getting 2.|-- ??? 100.0 10 0.0 0.0 0.0 0.0 0.0 Also the speedtest result i am getting 50% of ISP speed, please help Thanks
    • Answered
    • over 1 year ago
    • Sophos Firewall
    • Discussions
  • 15 MB/s

    Sophos User5900
    Sophos User5900
    15 MB/s, respektive 120 Mbit/s sind der Wert, welche meine beiden SG135 v.2 unter SFOS 18.5.2 Home bei einer IPsec site-to-site Verbindung erreichen. Dies ist ausreichend für RDP-Verbindungen, sich das eine oder ander File aus dem anderen Netz zu holen…
    • Answered
    • over 2 years ago
    • Sophos Firewall
    • German Forum
  • Katastrophaler Datendurchsatz im Vergleich XG - UTM

    Blacksmith
    Blacksmith
    Er mal wieder. Folgende Config liegt an einer Außenstelle noch an: UTM mit Deutsche Glasfaser 600 Mbit und einmal Telekom DSL 50 MBIT. Das gleiche auf einer parallel aufgezogen. Datendurchsatz bei der UTM: 600 bzw. 50 mbit! Datendurchsatz bei der XG:…
    • over 2 years ago
    • Sophos Firewall
    • German Forum
  • View related content from anywhere
  • More
  • Cancel
<>