I will preface this by saying I had a UTM120 for three years with the UTM9 OS and right now thinking boy I miss those days. I was told that my appliance was nearing end-of-life so to renew licensing I went with the XG115. I had configured UTM9 on my own…
Morning,
Just a quick question. Is it possible to configure two ports into a completely transparent bridge? Basically, I want traffic to flow into one port on my device and out of another without it ever "seeing" the XG software. Obviously, I want…
I am pretty new to Sophos firewalls so this may seem a basic question. I want to set up an XG firewall at home with the possibility to remove it as simply as possible in case of issues. What I think will work is this:
WAN - VDSL to ISP
ISP Modem…
Hi again, sorry for being asking a lot :(
I have a bridge (bridge 1) with 3 interfaces, 1 is for wan and 2,3 are for LAN, im also using dhcp realy for bridge 1, so i would like to know if its possible to create 1 firewall rule for the devices conected…
Hi all,
I have a 105w and I want to bridge a physical port and a wireless network, they should get IP from a DHCP internal server.
So here are my questions about it:
1. When I create the bridge port, both ports have to be in the same zone?
2…
So say you have Asymmetric Routing between Network-A and Network-B so you are testing the XG in bridge mode between each network which are in LAN zone.
you configure the XG to bypass-state-firewall-config add source Network-A dest_ Network-B
then…
Hello. I have been experimenting with Sophos XG in ESXI environment. I have it set up with 3 vSwitches (LAN, DMZ, WAN). DMZ and WAN are bridged so computers on DMZ can have external IP (same subnet as XG WAN port). For some reason, now VPN profile doesnt…
I have recently got myself a /29 subnet of public IPs from our ISP for hosting some extra services on-premises. I am wondering what the recommended way for setting these up through an XG would be?
My initial thought was to expose the public subnet on…
Hi Sachin,
you're right. I just disable and re-enable the auth cta in Sophos Console, and everything started up succesfully.
To disable, go to sophos console, option 4:
system auth cta disable.
To re-enable and add a collector:
system auth cta…
I'm looking to set-up XG Home with a PPPOE want on a VDSL connection that requires a VLAN tag. I cannot see an obvious way to do that. Is it doable, if not then I assume my options are either UTM or deal with double NAT of modem/router giving out a NAT…
Thanks for the answer Daniel,
so, if the Gateway 192.168.8.1 (WAN side) is the router that has all the VLAN declared, I don't need to add any static route on the Sophos XG? Or I should add the IP of the core switch on the LAN side?
e.g. if the IP…
I tried to set via the wizard tobridge mode, after that i have no acess anymore. Only 2 of the 8 lan ports are active and on both i have no acess. I checked the adress via console and everything is fine.
What can i do?