I just want to state that after spending many hours trying to figure out why Fast Transitioning wasn't working on my two AP100C APs is because XG firewall ( SFOS 18.5.2 MR-2-Build380) is setting the wrong config option in the the /etc/config/wireless…

Hi, on APX530 it is possible to set The 5 GHz Channel to 100 and above. Is this not possible on the APX320? Thanks for your help Greetings Andreas

Hallo, ich habe an einer Sophos XGS 116 zwei Access Point angeschlossen. Ich habe Clients im Netzwerk die sich mit dem falschen AP verbinden und dadurch eine sehr schwache Verbindung haben. Besteht die Möglichkeit in der Sophos, den Clients fest…

Hello. I have 3 new APX 320 which are stuck in a firmware update loop. XGS3100 (SFOS 18.5.2 MR-2-Build380) AP Firmware: 11.0.018 Messages: [<SN>] sent firmware /content/apfw/APX.uimage to device, releasing connection. 18004 Successfully sent…

Hello fellow Sophos XG users, I have a strange problem that I need some help with. The problem corresponds to the following discussion: Wifi Seperate Zone Performance - Discussions - Sophos (XG) Firewall - Sophos Community The installation is as follows…

hello, if I want to migrate an AP from a SG to a XGS, do I have to remove it from the SG or will it also be recognized by the XGS if it was not removed in the SG. Thank You!

Hi There, I am having a different issue in my network, Whats-App calls working on LAN via Whats-App desktop app but not on Sophos Wireless network on cellphones. I am having a XG2100 Firewall and APX320 APs.. Please suggest a solution.

Hi everyone, we created a BO and connected this site with the HO over a RED60 without VLAN tagging. So far so good :-). Now we would like to enroll some AP's in the BO with a setup similar to the HO. In the HO, we make use of Unifi HD nano AP's with…

Hi, What to do? I have a RED20 working correct with Xg Firewall 18.x - when I connect a laptop in LAN port, receive correct IP address through XG DHCP server - can access the remote network I have a Sophos APX320 Wifi access point connected…

Hello, i have a big problem. At the Moment i have a migration from SG UTM 9 tu Sophos XGS. Everthing works fine, except Wireless. I disconnected the old Sophos UTM and Connected the Sophos XGS to the LAN. The APX AccessPoints immediatly appears…

Hello, does anybody know when WPA3 is supported with the Sophos APX APs? I wonder why it is not released yet. Thank you!

Hello all, i'm new in this community. So i have a Sophos xg 105w firewall with a installed home use license. I've just one problem, i do not find any wifi interface. I already search in this community but didn't find anything. Have anybody a Solution…

Hi folks, in my home environment i have a Sophos XG home V18.5 mr2 with 2xAP100 and 1xAP55 accesspoints controlled via the XG Firewall. When i now moving with my devices (iphone, ipad, macbook, notebook,...) around my house, then the devices should…

I am having issue on 18.5 MR1 with AP15. Wi-FI goes down and only reboot is the way to get wireless lan again. Looking at the wc_remote.log, here what happens when the wi-fi stacks: 30>Jan 21 08:58:56 A4004F40C263B03 hostapd: wlan0: STA a0:d0:dc:2c…

I configured a Wireless -> hotspot and it works fine but only if the ip address is in the same subnet of the UTM. If the hosted is routed I'm getting this error: The UTM ip is 172.16.0.0.16 If the client ip is 172.16.0.0.X, the hotspot login…

I have implemented Sophos XG on an old computer. I am very happy with it so far. But I was wondering if it could address an annoying challenge that I am facing these days. I have a 5yo child who plays games on an android device, and those games are bombarded…

Hello everyone, after restarting the two APX 120 that we are using, a network loop is caused. If I disconnect the AP´s from the network, everything works fine again. I have replaced all cables and used different ports. They are directly connected to…

Hello all, I have two networks in our LAN zone: 10.0.180.0/24 10.2.180.0/24 Here is the interface config: We have a LAN-to-LAN rule that I would assume should allow traffic between hosts on either network: From either network…

I have been handed a task to add a Ubiquiti Nano AP to an existing XG125w network to extend range for an office that's too far away from the XG to get good service. DHCP is provided by Domain controller on the network Goal is for the Unifi AP to be…

Hello, I have a problem and I have no idea where to look, maybe someone can give me a tip. I have an XG115 to which an APX120 is connected. The AP is a member of a MESH and serves as a root AP (5 Ghz). The AP also broadcasts the client SSIDs in 2.4 Ghz…

Hello, AP Firmware 11.0.016 is now available. Where are the release note, please ?

Hi I am using sophos xg v18 utm We have multiple access points in our network. We have applied WPA-psk security on the same.The problem is that the key gets leak to all employees very easily and they connect their personal devices snd use internet…

Is there a way to create a vlan allow connected devices (via AP) bypass firewall? My current SSID in Vlan has a different IP subnet from my home devices. There are times I want to connect devices that totally bypass home firewall. This setup doesn't…

We have a new office with an XGS 2100 which is connected to our central UTM SG via RED. We have created a bridge on both sides for the office LAN and multiple WiFi networks. All traffic is routed via the central UTM. (UTM is default gateway) Our WiFi…

Hey guys. I would love to get your opinion and help on this. I have XG135W and four APX120. With machines connected directly via ethernet has no speed issues. However any wifi devices are experiencing 1/4 of the speed. As a test, I connected google…