This new KB article provides step-by-step instructions on how to deploy XG Firewalls in HA in your Microsoft Azure environment. It has been divided into 3 sections: 1. Workers configuration 2. Controller configuration 3. Observer configuration …

Hi, I am trying do configure the following scenario. Azure: - Virtual LAN (10.200.0.0/24) with Virtual Network Gateway (10.200.1.254 with the LAN 10.200.1.0/24) - VPN S2S connection with PSK - BGP ASN 65515 XG - LAN (192.168.97.0…

I have networking condition in Azure and believe I could be close based on what I've been reading. As it stands, I can ping/access the Sophos Azure XG from the Azure VM but not the reverse. Meaning I cannot ping the Azure VM from the XG. Packet cap shows…

I have a Sophos XG Virtual Appliance in Azure. I am unable to route Internet traffic from my Windows VM in Azure. I also have an on prem XG 230 with VPN established to the Sophos XG in Azure. My laptop can reach the Windows VM's fine. Once RDP'd, I…

Hello, I lodged a case with Sophos over the phone [7462215] a few days and called through each day with the response of "the engineer assigned to the case is unavailable, and there is no one else who can take the job, we will call you back" followed…

I'm trying to deploy an XG appliance PAYG on Azure but the deployment always fails. How can I get support to get a successful deployment? It doesn't give me any way to report the problem to Sophos in Azure. StatusMessage { "error": { "code…

Hi, We previously set up multiple Azure Site to Site VPNs using TMG and have added the VMs on those tenants to our domain. We recently got a Sophos XG115 and struggling to set up a Azure Site to Site VPN. I managed to get the VPN to connect, however…

I recently setup a trial of SFOS 16.01.1 on Azure RM (not Classic). I have XG230 on SFOS 15.01.0 MR-3 that I created a S2S VPN with. The connection is green and it shows some data (very little) has passed through. The issue is that I can't communicate…

I wrote a blog on this and a script to do the job (I will be recording a video on this later today which I'll link below). Please see both links below. All you need to do is edit the variables section and you're good to go! Happy deploying :) github…