Hello I have struggled for a while with this. And all while having serious network issues with Comcast. I have Comcast and AT&T as ISPs - and for background, I have forced their Internet cable modems / routers to have a base IP address in the 172.16…

Hi All I recently picked up an XG125 as I wanted to install XG home on it, which I have done, but port one (lan) and port two (wan) have no activity and I am unable to connect to the device via https://<IPADDRESS>:4444 Has any had any success with…

am working on installing the XG home firewall and was wondering where the quick start guide is. I am looking for the default IP address and password that is needed also a guide to the basic set up of the interfaces and should be set up for DHCP server…

The server I have in my lab has 4x10G SFP+ and 4x1gbit ethernet built into the board. Sophos is detecting the 4xSFP+ and only 1x1gbit. Is there anyway to force Sophos to see all 8 or have it ignore the 4x10G SFP+? It looks like Linux under the hood but…

I have a device with 3 ports, Port 1 is 172.16.16.16 and works, hands out IP addresses OK. Subnet is 255.255.255.0 Port 2 is WAN, working OK Port 3 in LAN, tried Static IP, DHCP but it will not hand out IP addresses. Tried adding DHCP, but…

Hello, I have replaced my EE router with a TPLink AC2800, but keeping the EE router as a backup. I want to setup a Sophos XG firewall at home in router mode and have put the TP-Link in bridge mode. Do I need to put the VLAN into both the TP-Link and…

Hello everyone if you please help me about this issue i m trying to solve. I installed vm XG Home Edition in Synology Nas but i cannot bridge the WAN with LAN. I want ISP Router to act as DHCP Server as it is, so my thought is to pass the traffic through…

I was staging a Sophos XG(Software) using an internal network. Everything was working fine. However, when I change the WAN to a 4G modem with static IP and passthrough, I was unable to access the internet from the LAN or other subnet. WAN IP was correct…