Hello all, 1.) I've heard some rumors that sophos firewall home edition will be end of life at some point in that not too distant future, is there any truth to this? 2.) Are there any fanless mini multi NIC pcs that have 2.5gbe that the sophos utm…

Hello My clients have a range of XGS107w and XGS 116/126 models, I understand the 126 models can accommodate an LTE module but what are people using for 4G/5G backup options on these lower spec routers? Any help would be greatly appreciated. Thank…

Hi, I'm new to the Sophos Firewall, but not firewall products in general. I've been running pfsense/opnsense for years, and thought I might give it a try. I can get it to boot just fine in a Proxmox VM, but on dedicated hardware it seems to be problematic…

I see from searching it, Sophos does not support i225v. But what about i226-V 2.5G ports? Also, I have a home-office, would Sophos Firewall Home (installed on a hardware device) be enough security for my home-office network? I'm the only employee /…

Hello, I have a Minisforum MS-01 which have two Intel 2.5GbE and two Intel x710 SFP+. I'm using Proxmox and I did a PCIe passthrough of one x710 interface (tick/untick pass all feature doesn't matter) to Sophos XG v20 Virtual Machine. By doing an…

Hi everyone! Is there a list of UPS vendor/models compatible with Sophos Firewall that can be used to shut down in the event of a power failure? Thanks.

Hi! I have a problem that I can't deal with. I have an HP 600 G3 Mini. There is one built-in network card. I bought an additional Ethernet network card connected via USB. Sophos itself does not support USB network cards from what I can see, but Proxmox…

Quick question: Do you have to have Sophos Hardware to make VLAN work in the firewall software? I'm using a mini pc running Sophos Firewall V20 and it appears when I set up a VLAN, it doesn't work. Followed the directions on how to create a VLAN but…

Hi Habe mir eine Frankenstein Firewall aus einem Supermicro X10SLH-LN6TF / N6-ST031, 32GB 1333 ECC UDIMM und einem Xeon E3-1281 v3 gebastelt. Da drauf läuft ein ESXi. Auf dem ESXi bin ich opensense, pfsense und sophos am testen. Mein Favorit ist die…

I’m looking for some advice for Hardware for the Sophos Firewall Home Edition. I’m not sure if I should use a vm or bare-metal installation. When I was looking for some hardware, I found HPE ProLiant MicroServer Gen10 Plus v2 with an Intel Pentium…

NIC not seen in console. Is there a way to get drivers for this? It shows up in BIOS of the server etc. But unable to configure/add in the main interfaces

Hi, I,m going to install Sophos XG home edition to a Protectli vp2420, I know the 4 core and 6GB ram limitation but with 300mb/s internet bandwidth it should be enough. It would be possible to install Sophos in Raid 1 if I provide Protectli with 2…

Hi everyone I installed my Sophos Home on a Mini-PC but it does not shows my NICs up. specs Intel Celeron J4125 8 GB RAM 256 GB SSD 4x 2.5 GBps LAN (i226-V) Any idea what can solve my problem? Thx

Hi, I'm not sure if I have just locked myself out of using XG home firewaill because of an unexpected BIOS compatibility issue. My ancient PC (Pentium III) mobo died. It was running XG 19.x. Researching for microPC's (ServeTheHome, Tom's Hardware…

Does the newly released SFOS v20 support newer fanless PCs containing the intel i225 ethernet chips, WITHOUT resorting to a VM? I suppose this is a resurrection of the question that was answered in the negative for v. 19.x last year in Does Sophos XG…

Hi Habe mir ein Supermicro Barebone mit 6x 10 Gbit RJ45 Kupfer, E3-1281 v3 und 32 GB ECC UDIMM 1333 geholt. Dachte mir, ich hau da vSphere 7 drauf. Da drüber dann Sophos XG home oder eine Sense. Bin gerade beides virtuell am antesten. Bislang habe…

hi I have a Cyberoam CR100ing firewall (1.6.3 MR-4) in my hands that I got from my previous job and I plan to install the new Sophos XG home edition OS on it since it is the most compatible with the hardware today. What happens is that the Cyberoam cr100ing…

Dear Community Member, during the task to refresh our firewall Hardware, we try to install SW-19.5.3_MR-3-652.iso on Dell PowerEdge R350 but it fails, mount iso over idrac stuck at ISO boot without any output. Secound try was to make USB Boot Stick…

I have some questions regarding deploying the Sophos Firewall Home Edition. Does anyone have any recommendations on hardware to use and to avoid? I would like to look into something small and compact if possible. A plus if it's easily mountable…

Hi Everyone in the Sophos Community. I downloaded the ISO for the Sophos Firewall Home Edition-Free Version and used Rufus to burn it to a flash drive. I am trying to install it on my Dell Opiplex 9010 Desktop PC but when I boot to the flash drive it…

Hello, I am trying to install sophos for home use on my old Lenovo 720q on nvme and after installation is not booting Bios is in Legacy, nvme first to boot. My Hardware: CPU i3 Nvme 512gb 8 GB ram(i can boost to 32gb if needed additional…

I recently purchased a server to use with Sophos XG Home Edition. It's a Supermicro SuperServer 5019S-W4TR. Motherboard is an X11SSW-4TF. I also bought a Lenovo Intel P4511 1TB M.2 NVMe for use as the boot/system drive onto which I was going to install…

My friend decided to run FW Home on my recommendation, but he's having trouble and I took the machine home to troubleshoot. Five days later, I still haven't found the issue. SFVH (SFOS 19.5.2 MR-2-Build624) Lenovo ThinkCentre SFF PC Intel Core i3…

I use a ZBOX CI 323 with XG 17.5, which works flawlessly, but I can't upgrade to the newer 18.0, since this version will not recognize the second LAN port on the device, which is used for WAN access. Using a USB LAN adapter also won't work. Anyone have…

I am interested in obtaining the expertise and opinion of a professional to ensure that the XG Home functions correctly before making a purchase this mini PC. www.aliexpress.com/.../1005005391181355.html Intel Celeron J4125 2.0GHz Quad Cores 8G RAM…