I have two ASG220 firewalls in HA Mode and I have a question when using Link Aggregation. Seeing one Firewall is active and other is standby. Do I also make 2 Link Aggregation groups on a Cisco Switch? One with the ports of each firewall??

Hello folks I encountered a strange situation which I cannot resolve using backup/restore and/or clean re-install. The Setup I have a 2 node virtualized setup like in the attached simplified image. I'm using the home edition of Sophos UTM 9.405…

Hi, I would like to know if it is possible to setup a HA with heartbeat link going through switches (LAG3 port 7&8). There are two datacenter, each one has 2 switches. Thanks for your help

We've been running pre-9.4xx releases on SG450 smoothly since initial deployment. However, after upgrading to 9.402-7 in Jun, unexpected httpproxy segfault comes: /var/log/kernel/2016/06/kernel-2016-06-15.log.gz:2016:06:15-17:10:43 sophos450-2 kernel…

This morning we had an HA failover where the slave became master. What I noticed after the failover is that logging (graphs) were not available in the period before the failover. This evening I let the previous master become master again and now I can…

Hi I have two nodes in an active/active cluster and want to be able to monitor the uplink interface to the internet on the slave node. When I log into the UTM, I get the Master unit and status of the interfaces on the dashboard, but I dont see anything…

Hi, We are using internet link from two different ISPs to have redundancy. Both links are terminated in UTM through a single cable running from each ISP provided device. Now we are adding another UTM for HA (A/P) but as only single cable is running…

Hi all I have a slight issue. We use Hyper-v as our Hyper-visor. I have configured 1 UTM which is live and is working fine. I have also configured another UTM to allow me to configure HA across two separate hosts. However the issue is when I enable…

Hello, We're having some troubles with our SG230 cluster. We have read this post https://www.sophos.com/en-us/support/knowledgebase/116131.aspx , so we were enough confident about the service availability during the updates. I'll go to explain the facts…

Trying to configure UTM 9 HA on VMware to test out HA and ensure it works prior to committing to purchase and use in production, but the HA Configuration "Sync NIC" list is empty (no NICS to select from shown). - Defined 3 VMXNET 3 vNICS (internal,…