I tell you that during the migration of a Fortinet FW to Sophos, we have some doubts about the routing issue. Example: Routing to Migrate Destination IP/Mask 172.17.0.0/255.255.0.0 Device: VPN-Gto (This is a Site to Site tunnel, however, even putting…

Hi Sophos Community, I am struggling to route traffic between two sophos over the Point to Point Connectivity as i am deploying my project in Eve Simulator but its not routing the traffic from the 10.10.0.5 PC towards the 192.168.3.30 Win Server and…

Why does the XG210, for the purposes of configuring a static route, require a different Gateway IP address from the VLAN Interface IP address? Trying to get my head around to understanding this static routing thingy on the XG210.

Hi, I have VLAN and for that I have configured Static Routes. Is that I can configure ARP Proxy instead of Static Routes. Manish

Hi, I have configured VLANs so for that I have configured static routes. Now as I am gaining knowledge I thought to configure Route Aggregation / Super netting instead of Static Routes. Is it possible to configure and if yes how ? Can anyone advise…

Hi. Many thanks for reading this, I am hoping someone may be able to throw some light on what I am trying to achive. I am new to the Sophos XG platform but I assume what I am trying to do is possible. Here is my scenario. Two companies in the same…

How do i Configure static routes to below IPs with next hop 100.100.100.6? 83.111.145.225 83.111.145.226 94.57.104.1 94.57.104.2 94.57.104.3 94.57.104.4 94.57.104.5 94.57.104.6 94.57.104.7

Due to the nature of my home network, i found it necessary to provide a static route to clients one of my subnets, as I have another subnet hanging off the end (bad design, I know, but it's practical, cheap, and it works). I couldn't find the syntax for…

Im trying to setup failover connections so that in the event of our WAN (P2P) connection fails the sophos auto fails over to our WAN (VPN) connection. the wan P2P connection also has static routes enabled so these would need to failover aswell.

Hi Guys, I'm starting to learn Sophos XG and stumble upon this two images below. I would appreciate if someone help me visualize the said pictures since I'm having a hard time understanding it a (a high level diagram maybe?). Also I'm a little bit confuse…

Hi everyone, Below is a rough sketch on my network. VLANs have been set on and by the ISP on their side. VLAN1 is for data. Which means PCs on the left should communicate with those on the right and vice. From the right I can only ping upto the Sophos…

So I have two sites (RED 15) that are talking back to my XG 210. At most of my locations they have an existing infrastructure (network, ISP, gateway, etc). I'm adding a secondary network (ISP, network, with RED 15) which will eventually be replacing…

Hello, I've to add a route to join a network behind a router connected to PortD of a Sophos XG. If I add a static route, i'm able to join the remote network, but if i'm doing the same configuration with policy routing, I'm not able to join the…