• VRRP between two bridged interfaces

    DavidBASQUIN
    DavidBASQUIN
    Hi everyone, I'm trying to make our ISP routers' VRRP work. Both routers are connected to physical interfaces on a SG330 cluster like this: RTR1 <> FW1/eth6 RTR1 <> FW2/eth6 RTR2 <> FW1/eth7 RTR2 <> FW2/eth7 I expected the bridging of my eth6 and…
    • over 8 years ago
    • UTM Firewall
    • Network Protection: Firewall, NAT, QoS, & IPS
  • Setup PPPOE Wan with VLAN tag for VDSL

    JarrodPoynton
    JarrodPoynton
    I'm looking to set-up XG Home with a PPPOE want on a VDSL connection that requires a VLAN tag. I cannot see an obvious way to do that. Is it doable, if not then I assume my options are either UTM or deal with double NAT of modem/router giving out a NAT…
    • over 8 years ago
    • Sophos Firewall
    • Discussions
  • RE: Is it possible to configure Layer 2 sub-interfaces in Bridge mode?

    JoseCasanova
    JoseCasanova
    Thanks for the answer Daniel, so, if the Gateway 192.168.8.1 (WAN side) is the router that has all the VLAN declared, I don't need to add any static route on the Sophos XG? Or I should add the IP of the core switch on the LAN side? e.g. if the IP…
    • over 8 years ago
    • Sophos Firewall
    • Discussions
  • No Acess after setting wizard to bridge mode

    DAENG
    DAENG
    I tried to set via the wizard tobridge mode, after that i have no acess anymore. Only 2 of the 8 lan ports are active and on both i have no acess. I checked the adress via console and everything is fine. What can i do?
    • over 8 years ago
    • Sophos Firewall
    • Discussions
  • Hotel Wifi -> UTM Ethernet port

    N8XJA1
    N8XJA1
    I stay in a lot of hotels. I would like to find an ethernet wifi device that either bridges/routes (prefer bridge) hotel wifi to they ethernet port on a (small) UTM. Does such a creature exists? Thanks
    • over 8 years ago
    • UTM Firewall
    • Management, Networking, Logging and Reporting
  • Need help with bridge in a vm (esxi 6)

    DillionPark
    DillionPark
    I have ESXi 6 with 2 physical NICs (eth 0 and 1) and I have 3 vnics (external, bypass, internal). I have a firewall with eth0 binded to external for Internet access. Then the firewall has a vnic for internal traffic (bypass). I then have sophos utm bridge…
    • Answered
    • over 8 years ago
    • UTM Firewall
    • Hardware, Installation, Up2Date, Licensing
<