Hello all,
i'm new in this community. So i have a Sophos xg 105w firewall with a installed home use license. I've just one problem, i do not find any wifi interface.
I already search in this community but didn't find anything.
Have anybody a Solution…
Hi folks,
in my home environment i have a Sophos XG home V18.5 mr2 with 2xAP100 and 1xAP55 accesspoints controlled via the XG Firewall.
When i now moving with my devices (iphone, ipad, macbook, notebook,...) around my house, then the devices should…
I am having issue on 18.5 MR1 with AP15. Wi-FI goes down and only reboot is the way to get wireless lan again.
Looking at the wc_remote.log, here what happens when the wi-fi stacks:
30>Jan 21 08:58:56 A4004F40C263B03 hostapd: wlan0: STA a0:d0:dc:2c…
I configured a Wireless -> hotspot and it works fine but only if the ip address is in the same subnet of the UTM. If the hosted is routed I'm getting this error:
The UTM ip is 172.16.0.0.16
If the client ip is 172.16.0.0.X, the hotspot login page…
I have an open ticket on this issue however; I am not receiving a response. I recently transition our wireless environment to support VLANs. We a had 2 networks that were set to bridge to the AP LAN (VLAN 2). I disabled those networks on our access points…
I configured a Wireless -> hotspot and it works fine but only if the ip address is in the same subnet of the UTM. If the hosted is routed I'm getting this error:
The UTM ip is 172.16.0.0.16
If the client ip is 172.16.0.0.X, the hotspot login…
I have implemented Sophos XG on an old computer. I am very happy with it so far. But I was wondering if it could address an annoying challenge that I am facing these days. I have a 5yo child who plays games on an android device, and those games are bombarded…
Hello everyone,
after restarting the two APX 120 that we are using, a network loop is caused. If I disconnect the AP´s from the network, everything works fine again. I have replaced all cables and used different ports. They are directly connected to…
Hello all,
I have two networks in our LAN zone:
10.0.180.0/24
10.2.180.0/24
Here is the interface config:
We have a LAN-to-LAN rule that I would assume should allow traffic between hosts on either network:
From either network…
I have been handed a task to add a Ubiquiti Nano AP to an existing XG125w network to extend range for an office that's too far away from the XG to get good service.
DHCP is provided by Domain controller on the network
Goal is for the Unifi AP to be…
Hello, I have a problem and I have no idea where to look, maybe someone can give me a tip. I have an XG115 to which an APX120 is connected. The AP is a member of a MESH and serves as a root AP (5 Ghz). The AP also broadcasts the client SSIDs in 2.4 Ghz…
Hi Community!
The AP firmware 11.0.018 has been released for Sophos Firewall OS (SFOS). This pattern update has a fix for APX 120 update issue which was discovered during AP Firmware 11.0.017 release.
News: Maintenance Release Bugfixes: NAF-143…
Hi Community!
The AP firmware 11.0.017 has been released for Sophos Firewall OS (SFOS). This pattern update has a fix for the recently discovered Wi-Fi vulnerabilities AKA FragAttacks in legacy Access Points. In addition to the patch, this update…
I was looking at the brochure comparing Sophos Central wireless management versus XG appliance wireless management ( https://www.sophos.com/en-us/medialibrary/PDFs/factsheets/sophos-wireless-licensing-guide.pdf ), and the row "MU-MIMO" has only a check…
Hi
I am using sophos xg v18 utm
We have multiple access points in our network. We have applied WPA-psk security on the same.The problem is that the key gets leak to all employees very easily and they connect their personal devices snd use internet…
Is there a way to create a vlan allow connected devices (via AP) bypass firewall?
My current SSID in Vlan has a different IP subnet from my home devices. There are times I want to connect devices that totally bypass home firewall. This setup doesn't…
We have a new office with an XGS 2100 which is connected to our central UTM SG via RED. We have created a bridge on both sides for the office LAN and multiple WiFi networks. All traffic is routed via the central UTM. (UTM is default gateway) Our WiFi…
Hey guys. I would love to get your opinion and help on this.
I have XG135W and four APX120. With machines connected directly via ethernet has no speed issues. However any wifi devices are experiencing 1/4 of the speed.
As a test, I connected google…
Hello,
we added some APX access points for customer guest wifi. We want to use one voucher for unlimited devices for e.g. 90 days.
Its seems like this is not possible in Sophos Central Wireless... Maximum amount of device is 8 and time period is limit…
Hi All,
for our home I´m looking for a WIFI and Router solution and won´t give UNIFY a go.
AFAIK the XG Home can be used at home for free including all features. Does this also include the management of Access Points like APX120.
If so, what…
Hello,
Is there a possibility to query if a specific wireless client (e.g. MAC address) is connected to the network or a specific APX Access Point through an API?
Thanks
Robert
I have connected my APX120 to the XG and created a new wireless network, basically same as the default sophos. Bridge to AP LAN.
Now I want to add another network with its own subnet, that will have access to my LAN on Port3.
So I created a vlan connected…
Hi,
I'm sharing fiberglass internet (bit expensive) with my neighbours, and we have installed XG home in a PC. We have created username and password for each user and installed quit a few access points and some routers to the network. But now we have…