Hi! I'm trying to figure out how to set up VLAN/DCHP/firewall rules for VoIP. The VoIP phones will not have separate network connections to a separate switch, they will run on the same cable and out to each workstation PC. This means a phone and a PC…

Hello to the whole community, I am trying to configure point access with my Sophos XG125 When I try to connect to Wifi which uses VLAN 1, I do not receive an IP address. When I connect with the network cable I get the IP address. When I connect…

Hi everyone, I have two IoT devices that need connected both wireless and wired on the same network. Wireless and wired (connected to a dedicated port of the FW via a switch) clients must have the same IP adress range (so the same DHCP). How I could…

Hello i just purchased this firewall and have the following setup I have 3 dhcp scopes: VLAN_500_SCOPE - 192.168.10.100 - 192.168.10.200 VLAN_600_SCOPE - 192.168.20.100 - 192.168.20.200 WFIF_SCOPE - 192.168.30.100 - 192.168.30.200 …

Hi, basically I wanted to add a second LAN Uplink from my Sophos XG device to a Linksys LGS308 Switch. I configured a LAG interface on both ends and it seemed to work (LACP was activated), since the XG interface dashboard showed to me that traffic is…

I have 4 remote locations connected via RED's where clients require access to DHCP on VLAN 20. I have created the following VLAN interfaces (Port8 is the local LAN interface): reds1.20 - 10.20.20.1/24 reds2.20 - 10.20.20.2/24 reds3.20 - 10.20.20.3…

Dear All, I have "small" problem with XG230/RED50 configuration: XG230 Port2 configured - WAN Port1 Default address 172.16.16.16/24 in LAN zone Vlan 2 and Vlan 3 are configured on Port1 also in LAN zone (Vlan2: 192.168.121.0/23, Vlan3…

Hi All, I am fairly new to the world of "Sophos". I need some help in setting up a guest WLAN on a VLAN through my Sophos XG 330. I have several unifi switches deployed and then connected to them are unifi access points. (I do not have unifi USG) I…

Que tal, tengo un problema para poder propagar varias redes sobre un mismo AP, quiero distribuir 3 vlans con direccionamiento independiente administradas por un XG 135. he buscado documentación que me ayude en ingles pero no hay. si alguien que hable…

Hallo. Ich habe eine Sophos UTM auf eigener Hardware mit Homelizenz an einem Telekom VDSL100 Anschluss. Vor der UTM ist ein Zyxcel/speedlink Modem, hinter der UTM ein HP ProCurve 1810-8G Switch. Rechner aus dem LAN Netz 192.168.2.0/24 kommen ins Internet…

I have a server running UTM in Hyper V with 3 Interfaces. Interface 1: Goes to a modem for internet connection Interface 2: Goes to a Cisco Meraki 220 switch Interface 3: Virtual switch for other virtual machines running on the server I split…

Dear experts I recently received new hardware for my XG Home. Unfortunately, the configuration export was apparently not complete, so some settings had to be adopted manually. LAN Network looks good, although Firewall rules are missing completely, but…

Hi UTM 125 and AP55 AccessPoints here. I would like to put the AP55 Access Points in a seperated VLAN (Layer 2 Switches available). But I am already failing one step ahead, did not getting any ip adress of the DHCP Server. I have created an Ethernet…

I have an internal client vlan (VLAN12) that I need to pass to a remote office. I purchased a RED50 because the literature says, it can handle vlan’s. Only, I’ve tried every which way that is suggested by the Sophos Community and I cannot get it to work…

Hello, I did create couple VLANs and DHCP per each VLAN. I have added Static IP MAC Mapping but seams doesn't work at all. I have tried to disable NIC on client, restart client PC but no luck. Everything was working fine on Sophos XG 15 but…

Here is our current setup. Sophos UTM at the Gateway. A Dell PowerConnect 2824 managed switch, VMWARE esxi 6.0 running our virtual servers. Our accounting software has been locking up and I was advised by them to add them to their own vlan that network…

Hallo zusammen, ich bastel gerade an meinem Testsystem und stehe vor einem kleinen Problem. Zur Laborumgebung: vmWare virtualisierte Windows-Umgebung. Windows Server und Clients die Sophos UTM Diverse VLANs um Bereiche voneinander zu trennen…

I have two networks setup that are vlan tagged and on a LAG interface. I have a client that can connect to both of those networks and would like to assign a static IP address to that client on both networks. Initially I assigned a static IP address in…