Howdy folks. I have read a few other posts on folks configuring a DNAT for a Plex Media Server behind UTM. I've tried and beat my head against this, but it simply isn't forwarding traffic. What gives!!?!?! I have a network object defined for my Plex…

Hello All, We are migrating to Sophos SG330, I have some doubts because there is not corrispondence between Cisco Asa and Sophos. I would like to permit to our branch offices to communicate each other. We use IPSEC VPN tunnel. I think I should create…

We have an SG230 in a remote facility which we must make VPN connections to, preferably over L2TP/IPsec. The problem is that they haven't provided us with a public IP per se, instead they have given us a private IP which is 1:1 NATed in their firewall…

I have a localized network only (No internet/remote access) and have a client PC LAN a FTP server LAN and the Sophos UTM 210 all hanging off a Stongate intel security firewall. Effectively the SOPHOS is a hairpin device but FTP traffic from my client…

Hi, I have clients behind a router behind a sophos UTM which I am trying to get internet access but not sure where to go from here. My setup is below: Sophos UTM Connected to Modem (which connects to internet) LAN IP address of 192.168.1.1/30…

Hallo Community, Ich kenne mich leider mit dem Thema Sophos Firewall wenig aus. Beispieldarstellung: Ich habe 2 Interfaces (eth2 und eth4 an den vorderen Anschlüssen angeschlossen), welche in der Firewall auch angelegt sind (Interfaces & Routing…

I'm just setting Sophos up and haven't had too much trouble that wasn't caused by some small issue, so I'm guessing this is the same. I've went through and set up the NAT Rules , but it's still not working. The domain name can be accessed outside of the…

Posting this question again on the new forum.. Here is the link to the old: https://www.astaro.org/gateway-products/network-protection-firewall-nat-qos-ips/59993-additional-address-stops-responding.html Still battling this problem. Wondering if it is…