We have multiple manufacturing sites within the US, each site has its own T1 for private WAN and its own internet connection as a backup to the T1. Despite pulling as much traffic out of the private WAN as possible, we have grown out of the T1's (shocker…

Hello, This has been going on for a little over a month now and seems to be getting worse. We have a RED 50 connected to our UTM 220 and following recent firmware upgrades (I think) it has become unstable. I see lots of other similar cases out there…

Hat jemand Erfahrung ob die Verbindung mit einem Red Device (15/50) und der aktuellen UTM 9 stabil in Verbindung mit einem Telekom Hybrid Anschluss funktioniert? Szenario: An einem Außenstandort ist nur DSL mit 16Mbit verfügbar (wenn überhaupt) und…

Hi all, in my setup one UTM with two uplinks acts as RED server and another UTM with two uplinks as RED client. Both systems are connected by RED site to site tunnel. I want the RED tunnel to use a specific uplink on the client side. I tried multipath…

Good morning, Does anyone Else have the problems or have an idea what the problem might be. We have a Headoffice Thats has a Server Running a ERP. the database Uses Firebird. when we connect to the server in the headoffice the program runs great.…

Hello, We have three devices in our network. ADSL Router: WAN IP - 185.168.41.75 (static) LAN IP - 192.168.1.1 RED10: WAN IP - 192.168.1.2 LAN IP - 50.50.50.1 CCTV DVR: Port - 91 LAN IP - 50.50.50.233 We would like to…

Hi all, we could implement a basically working L2 lan interconnect with a UTM9-UTM9 RED tunnel. There are two problems for which we need a solution: 1. the RED server site has 3 WAN uplinks. We would like to bind the RED tunnel to a specific WAN uplink…

Right now my company just moved to a new UTM and we upgraded a few REDs to the RED15rev1. I read in the documentation that you needed to allow UDP3410 so it can communicate properly. Would we need just create a service definition for this port and allow…

We have a client with two sites. The main site has several subnets, on different interfaces of the UTM. The remote site has one subnet. Communications between the sites was facilitated by RED link (UTM as RED). This has been working perfectly for some…

We have some IP phones at a remote site which has limited bandwidth (currently connected to a RED50 using a standard / split tunnel) I am trying to setup a QOS rule so the phones always get a reserved chunk of the bandwidth as the site often maxes…

Hi is there any command to get the IPs of the connected REDs via command-line? I already tried cc get red but it only shows the internal name of the REDs, certs and so on, but no IPs. Regards Rolf

I would like to connect a RED device out of line, so that its WAN interface is connected to the local LAN. This works and connects back to the UTM but can I then point a server at the RED WAN interface and have the RED route it out? Does anybody have…

Our recent PCI Compliance scan came back failed because the RED service uses RC4-SHA. This is also one of the issues that the scanning company (Trustwave, who is used by our credit card processor, FirstData) will not allow to be overridden. If this is…