I posted a similar question in the Wireless forum over a week ago, but got no replies, so I am trying in the general area. I am replacing my current access points with Sophos AP 100C models, to be run from the current UTM 9.7 software. The AP 100C is…

Hi, I have a SG115rev2 that has been running for a few years. Currently on SFOS 18.5.1 MR-1-Build326. There are 4 ports on my SG115 with port1 connected to my LAN switch and port2 connected to my WAN broadband modem. All works great. I have a spare…

Hello, I have problems updating to v19. As soon as I install the v19 update, my AP100 (3 pieces) remain inactive (1 ROOT 2 MESH). Only the ROOT emits WiFi despite the inactive message. As soon as I go back down to 17.5, everything is active again and…

Hello Guys! We manage about 30 Sophos XG Firewalls which we also have to update for sure. Now with the recent Access Point Firmware Update, which you have to do to keep new APs working, i need to access every firewall and click the install button. Now…

After upgrading one XGS and XG from 18.5 MR3 to MR4 we have issues with our Sophos Central managed APX Accesspoints showing as offline in Central after between 30 and 60 minutes after the upgrade of the Firewall. See: https://community.sophos.com/sophos…

I have one location that unlike other locations, wifi AP's are not controlled by the local XG UTM, but rather they ( APX320X) are controlled via Sophos Central. I have setup a guest type network not bridged to the local LAN zone networks and the IP…

I would like to get some advice from you on setting up wifi access from the Sophos firewall as I see there are other spare LAN ports. Problem now: I have various wifi access points on various floors connected to a separate network and switch as I need…

Hi, I know Managing AP55C on XGS has been disabled but the AP is still supported in Central. We replaced a SG with XGS. on SG there were 2 APs AP55C. We removed both APs from SG Firewall, then deleted the unregistered APs there and pulled the AP…

Hi forum, I have two AP55C's at home which work fine. The Sophos XG is also my gateway, i have a windows server 2022 DHCP server, so requests are being relayed to the server. On the DHCP server i use an option 003 with IP to my Sophos XG. So this setup…

I was planning to buy a second hand Sophos Wireless Access point but noticed the paragraph " Note: According to FCC regulations, all WLAN devices marketed and sold in the U.S. must be restricted to U.S. channels only. Therefore, the country code selection…

There is a new AP Firmware 11.0.019 but I can't find release notes. https://community.sophos.com/sophoswireless/b/blog

Hi, at a remote site we noticed 2 different problems that we could get fixed by AP reboot but were are hard to identify remotely. one APX530 had poor up- and downstream bandwidth: 16 Mbit down and 60 Mbit upstream an other APX530 failed to provide…

XG 18.5 MR2 managed AP55c are in VLAN and broadcast multiple SSID, some with hotspot, one with RADIUS, and multiple with WPA2 PSK. AP Firmware: 11.0.018 We first noticed problems on an AP where the users had mutiple disconnects over the day. this AP…

Good morning, we started up our new XGS3100 with FW 18.5.2 MR-2-Build380 this morning. Now we have the problem that all AP55 & AP55C stop on inactive. Officially the AP55&55C are still supported until 2023. Does anyone know the behaviour or have…

Hello, Since the management of AP WIFI on Sophos Central is free, we migrate the APs of our customers on Sophos Central Wireless. I'm writing to you because we have a problem with the migration of a WIFI AP on a Sophos XG to Sophos Central WIFI…

Hello all, We have an XG at our main site which is working well. It has a normal, bridged user network and a guest wireless network on a separate zone.. This all works fine. We deployed an AP at a branch office according to https://support.sophos…

I just want to state that after spending many hours trying to figure out why Fast Transitioning wasn't working on my two AP100C APs is because XG firewall ( SFOS 18.5.2 MR-2-Build380) is setting the wrong config option in the the /etc/config/wireless…

Hi, on APX530 it is possible to set The 5 GHz Channel to 100 and above. Is this not possible on the APX320? Thanks for your help Greetings Andreas

Hi, ich have created multiple Wireless Guest Networks. There were 3. I removed 2 of them. Everything was removed accept the Wireless Interfaces under ->Network->Interfaces Is it possible to remove them??

Hallo, ich habe an einer Sophos XGS 116 zwei Access Point angeschlossen. Ich habe Clients im Netzwerk die sich mit dem falschen AP verbinden und dadurch eine sehr schwache Verbindung haben. Besteht die Möglichkeit in der Sophos, den Clients fest…

Any update to when the WIFI 6 models will be released? I see mentions of it on the roadmap and release potentially last year. Any updates on these as I'm looking to upgrade my network with a new firewall with Sophos, but we require WIFI6

hello, if I want to migrate an AP from a SG to a XGS, do I have to remove it from the SG or will it also be recognized by the XGS if it was not removed in the SG. Thank You!

Hi There, I am having a different issue in my network, Whats-App calls working on LAN via Whats-App desktop app but not on Sophos Wireless network on cellphones. I am having a XG2100 Firewall and APX320 APs.. Please suggest a solution.

hello, what is the best way to migrate an APX 120 from an XGS to Central so that I can then manage it via Central Wireless? Thank you very much!

Hello, i have a big problem. At the Moment i have a migration from SG UTM 9 tu Sophos XGS. Everthing works fine, except Wireless. I disconnected the old Sophos UTM and Connected the Sophos XGS to the LAN. The APX AccessPoints immediatly appears…