• AP55 EOL set up. Strange blinking

    Tjorven Wendt
    Tjorven Wendt
    Hi, I got today two Sophos AP55 Accesspoints. The problem here is, I can not add in them Sophos Central. They wont appear there. Also they blink green green green then short red and again. What does that mean? I even dont know how to even reset them or…
    • 2 months ago
    • Community Chat
    • Discussions
  • AP15 fails to allow connections occasionally [UTM Home license] - logs help?

    gcracker
    gcracker
    Sophos UTM Home 9.705-3 AP15 single AP - no mesh Single SSID enabled I have been running UTM home for six years (2015) and the AP55 for five years (x-mas 2016). Last night, like happens a few times a month, my AP55 stopped allowing client association…
    • over 3 years ago
    • UTM Firewall
    • Wireless Security
  • How to set up SOPHOS AP behind a RED10 RED20 RED50 RED60 device.

    Steve Klassen
    Steve Klassen
    After I set up a RED20, I plugged an AP into it, as I wanted to have an AP behind the RED20. I have it in Split-Tunnel Mode. The issue I had was that the AP would not show up in the list of new APs to authorize, on the UTM side. I read many many posts…
    • over 3 years ago
    • UTM Firewall
    • Remote Ethernet Device (RED)
  • Wireless Devices 'Dropping Off' the Network

    SamFickling
    SamFickling
    Setup : Hardware: SG135 Software: UTM v9.705-3 APs: 2x AP55s Non-Standard Config: AP Country set to US (not to my actual location), for hardware compatibility reasons Problem: For at least the last year, wireless devices on my network have been intermittently…
    • over 3 years ago
    • UTM Firewall
    • Wireless Security
  • 4 Wireless AP inactive after Sophos restart

    Kekschen
    Kekschen
    Hi, we had a planned power failure 2 weeks ago, and since then four of 13 wireless AP´s AP55 are inactive. We got some other AP55´s with no problems. The AP´s itself were not affected by the power failure. They can be pinged in the network. A restart…
    • over 6 years ago
    • UTM Firewall
    • General Discussion
  • AP55 not appearing on VLAN

    ecar13
    ecar13
    I have an SG310 and an AP55 Access Point. I have a switch with 3 VLANS: - VLAN 1 is the default / LAN - VLAN 150 is called Management - VLAN 30 is WiFi If I plug my AP55 Access Point into a switch port that is untagged on VLAN 1, the AP55 gets an…
    • over 6 years ago
    • UTM Firewall
    • General Discussion
  • Configure AP55s with 2 SSIDs and 2 VLANs

    Tam Ben-Jusu
    Tam Ben-Jusu
    I have some AP55s connected to a XG230. They are broadcasting 1 SSID, Bridge to AP LAN, with no problems I would like them to broadcast another SSID (called guest) on a seprate VLAN. What's the best way to set this up? I can create the wireless…
    • over 6 years ago
    • UTM Firewall
    • Wireless Security
  • Bridge to VLAN - How to setup your UTM?

    Yves Schumacher
    Yves Schumacher
    Hello, I'm very tired of searching the web for an answer to my issues with my Wifi setup on my Sophos UTM. What is my setup? Sophos UTM 9.505-4 AP-55 What is my goal? Creating two SSIDs: The users of SSID A can access the internal…
    • over 6 years ago
    • UTM Firewall
    • Wireless Security
  • Wifi disappears when RED is offline for a short periode

    JosefBergmann
    JosefBergmann
    Hi all, I've a Sophos SG115 and a RED15 (in Standard/Unified-mode). Behind the RED is a AP55 connected to the LAN. I configured a simple wireless network with WPA2/AES bridged to the AP LAN. For the LAN behind the RED I've also setup a DHCP-Server.…
    • over 7 years ago
    • UTM Firewall
    • Wireless Security
  • UTM 125 + AP 55s + VLAN + DHCP server problems

    onit12
    onit12
    Hi UTM 125 and AP55 AccessPoints here. I would like to put the AP55 Access Points in a seperated VLAN (Layer 2 Switches available). But I am already failing one step ahead, did not getting any ip adress of the DHCP Server. I have created an Ethernet…
    • Answered
    • over 7 years ago
    • UTM Firewall
    • General Discussion
  • AP55 To RED15 To UTM v9

    Michael Robertson
    Michael Robertson
    Hi All, I'm having a weird problem with my AP, current IP address is 192.168.250.70, and can see AP in the UTM. I have an SSID called Employee with WPA2 Enterprise with a Radius in my Server Vlan. It seems the authenicate ok however when trying…
    • over 7 years ago
    • UTM Firewall
    • Remote Ethernet Device (RED)
  • Is there a 12V DC-IN PowerSupply for AP55/c available?

    RedVision81
    RedVision81
    Hi there, does somebody know if there is a 12V DC-IN Power Supply available for AP55/c? The APs have an Input for that, but we only can buy them with or without POE-Injector and currently there is only a PowerSupply for the AP15 available. We want to…
    • over 8 years ago
    • UTM Firewall
    • Wireless Security