HA active-passive preferred primary device

Documentation says for HA active-passive you should select a preferred primary device, because " only the initial primary device holds the licenses and supports services, such as FastPath offloading. ...
2 WAN-Links (use primary one, and only if failover the second) - Problem with DNAT on failover Interface

Hello, we have an question because in the past we have problems with DNAT when configuring our two WAN-links as active/passive. As a workaround we configured the two interfaces as active/active,...
Sophos Red 60 Reset

How can I factory reset my sophos red 60 manually using the reset button at the back. Also, is there a way we can access the red device through console or ssh?
Heartbeat over RED connection

Hi, What's the recommended configuration for clients behind a RED? We have the the RED in SPLIT tunnel mode and have the Sophos Heartbeat IP included in the traffic sent over the tunnel. Is this right...
Sophos Red 20 General Internet Access

Hi, We have a RED 20 device that we recently purchased as a test device before looking to set multiple up across different sites, however we have found that our organisation's manual proxy blocks any...