NAT rule not working anymore after Beta 2

Addition, this rule is from the internet to an internal server. PortC is the internet facing interface.

Unfortunately you will have to do packet capture if you can't see anything in the logs. I hate packet capture but we have to work with the tools that sophos throws our way.

I narrowed it down to an issue with beta 2. Here's the case: when I edit the firewall rule and press 'apply' without changing anything, then the rule works.

After a reboot of XG the rule stops working again until I edit the rule again and, without changing anything, press apply. Remote AP's immediately connect to the controller again. Until the next reboot of course.

Conclusion: for some reason after a reboot the rule stops working without any trace of it in the logs.

Franc.

I narrowed it down to an issue with beta 2. Here's the case: when I edit the firewall rule and press 'apply' without changing anything, then the rule works.

After a reboot of XG the rule stops working again until I edit the rule again and, without changing anything, press apply. Remote AP's immediately connect to the controller again. Until the next reboot of course.

Conclusion: for some reason after a reboot the rule stops working without any trace of it in the logs.

Franc.

Sending request for firewall_rule.log on PM.

hi FrancWest,

Thank you for the feedback.

Have you applied wildcard Fqdn host in firewall configuration!

I am sending you PM, please send me the require details.

Hi Franc,

Thank you very much for the feedback and your extended support to look into the issue.

We are tracking this issue through JIRA ID NC-22584.

Regards,

Deepti Bhavsar

Hi,

This issue was resolved in RC1. I can confirm it works fine now.

Regards,

Franc.

Ive found wildcard fqdn hosts are not resolving sub domains now, has anyone else found this?

Hi John,

Thank you for the feedback

Please check your DNS server.

Also check drop packet capture, if any dns request is getting dropped.

Regards,

Deepti