System Appliance Access does not work anymore

Hi,

in v19 EAP the CLI command "system appliance_access enable" does not work anymore. Previously this command would allow temporary access to WebAdmin/SSH of XG over any interface while traversing traffic is dropped.

Now a http/403 is being returned 

If I rollback to v18.5MR1, this works just fine.

This command is crucial when deploying XG in cloud environenments as you are not always in control of interface order and address configuration.

Honestly, this command saved the day multiple times considering the fact, that you couldn't configure all interfaces via CLI. Now, even this doesn't work.

Also, many cloud providers do provide /32 netmasks which result in no default routes being set on XG. It is ridiculous, that I cannot change this behaviour in v19 in console, since there is no other way via XG console to change the WAN port configuration except for Advanced Shell, which is disabled :]

Kind regards,

cougz

Parents Reply Children