Sophos XG QuickHA Home

Hi Akilae,

what does your HA screen show, mine shows ready to connect, if I had an interface active for it and also an extra XG?

Ian

Hi Akilae,

what does your HA screen show, mine shows ready to connect, if I had an interface active for it and also an extra XG?

Ian

Hey on my primary node I have the following HA settings.

My secondary node is as follows.

Hi Akilae 

Thanks for the feedback.Please share below command output from both appliance.

# cat /etc/version

also sending you PM for more details for further investigation.

Thanks,

Rana Sharma

Hi Akilae 

Thanks for sharing the information over PM. 

Based on the output you have shared.Below is the observation and recommendation 

• You are doing HA with different Flavour of SF Device : SO (Software ISO) and HV (HyperV) -> it must be same device
• Please take same device to do HA : SO and SO or HV and HV or any same hardware 
• Feel free to refer HA behaviour for the same  https://community.sophos.com/kb/en-us/123174#HA%20behavior 

SFOSv18 HA Configuration Guide : https://community.sophos.com/products/xg-firewall/sfos-eap/sfos-v18-early-access-program/f/recommended-reads/118047/sophos-xg-firewall-v18-how-to-configure-quick-ha

Feel free to get back to us once you face issue again

Thanks,

Rana Sharma