I have installed EAP3 Refresh 1 and HA does not work, i have port 1 for lan, port 2 WAN port 3 is my DMZ/Wireless and port 6 is setup for HA
on primary selected port 6 and set as quick and clicked initiate. it is in discovery mode
on the secondary went into HA set same key, and told the second unit to use port 6 for HA, wired directly to the primary unit, and it spins and then comes back and does nothing. will never configure the secondary unit. it acts like it will not work unless on port 6
This is Critical to get this to function. also if you try to select interactive it shows no ports that can be selected for HA.
