BUG - APs using the same 2.4ghz channel.

Hey,

Have you got Dyn Chan enabled in the Access Point Config?

(Wireless -> Access points)

Have you got time based Scan enabled? hopefully they are not both set to the same time

Hi Gavin,

yes, they have dynamic channel selection enabled and for a while there they were on different channels.

Ian

Hi Ian,

Being that close, have you got the power output turned down?

I run my 100C at 75%, as I was having issues with iPhones conencting when it was at 100%

Try setting a timechedule for the scan, and make sure both are at different times

Hi Gavin,

last discussion about this subject advised the scanning wasn't required.

I only added the second AP to overcome a problem with iPhones, IPv6, VLANs and clientless authenticating. I think the consensus last time this discussion occurred was tp split the SSIDs in two so that 2.4 and 5 were on different SSIDs.

Looks like a restructure wii be required to reduce the number of APs, remove the VLAns, two APs for 7 devices is a bit of an overkill.

Ian

Hi lan,

Can you please enable "Time-based scan" for both AP on 2.4Ghz band.? This feature should prevent you to get the same channel. 

Please try and let me know. 

Thanks.

Hi Sanni,

at this stage I haven't had to implement the time scan, the devices have worked out the issue by themselves, currently on different channels and have been for about 36 hours.

Ian

Hi Sanni,

at this stage I haven't had to implement the time scan, the devices have worked out the issue by themselves, currently on different channels and have been for about 36 hours.

Ian