This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How do I boot to previous firmware with Putty?

Hi All,

 

I 'upgraded' to firmware version 17 MR2 from 17 MR1.

 

Since the 'upgrade' I cannot access the web UI - I get a blank page with "Internal Server Error" in the top right corner in response to login submission.

 

I do not have easy access to connect a terminal cable but I can get access through Putty.

 

Is there a way to remove the MR2 or boot to MR1 using a connection with Putty?

 

Thanks 



This thread was automatically locked due to age.
Parents
  • Same issue with upgrading our boxes from 16.8 to 17.2. It showed both versions firmware installed in the console but 16.8 was the active firmware, with the inability to login to the web interface. All I can say is eventually the devices rebooted and 17.2 was running and has been running fine since. Frustrating the Quality Control on these is still so bad but glad it magically worked.

Reply
  • Same issue with upgrading our boxes from 16.8 to 17.2. It showed both versions firmware installed in the console but 16.8 was the active firmware, with the inability to login to the web interface. All I can say is eventually the devices rebooted and 17.2 was running and has been running fine since. Frustrating the Quality Control on these is still so bad but glad it magically worked.

Children
No Data