xg firewall home and nas or any devices on my network

Daniel,

if you are trying to access your internal servers externally, make sure your DSL modem has the proper DNAT to forward all traffic to XG WAN port, otherwise traffic is blocked on DSL modem.

If you already checked it, share the screenshot of the firewall rules you have created.

Thanks

Hi.

I cant do that because the sophos is on 192.168.2.Xx and my dsl router is on 192.168.1.Xx

It does notre accept IP on 192.168.2

Moreover, the sophos is on the dmz of my dsl router. So it should be right, no ?

make sure your DSL modem has the proper DNAT to forward all traffic to XG WAN port, otherwise traffic is blocked on DSL modem.

how do I do that if the dmz is not enough / ok ?

as you asked:

Thanks for sharing the screenshots.

Daniel, can you share the IP/Subnet for each network (wan, dmz, lan) for both DSL Modem and XG?

DMZ and WAN IP are not clear.

Thanks

hi

i do not understand what you want exactly.

Ip are written in the screenshot above.

tell me if it is not what you want:

wan : 192.168.1.18 / 255.255.255.0

ip of the gateway : 192.168.1.254 (my dsl router)

dmz : 192.168.1.18 (this ip is set on my dsl router)

lan : 192.168.2.1 /255.255.255.0

that's what you asked ?

So,

if I understand correctly, WAN and DMZ are using 192.168.1.x/24?

Thanks

yes.

you are right.

wan (on the sophos) is 192.168.1.18

the dmz is set on my router dsl.

dmz is 192.168.1.18 (the ip of the wan)

yes you're right

ip of the wan : 192.168.1.18

dmz set on my dsl router : the same ip as the wan.

Daniel,

you cannot have 2 ip in the same subnet on 2 different interfaces. This will confuse the routing table.

Make sure on your router you configure 2 different IP for WAN and DMZ interface.

Thanks

i do not understand.

the wan is the port2 on the sophos.

the dmz is set on my dsl router.

what do you mean by "make sure on your router you configure 2 different IP for WAN and DMZ "

On my dsl router, i only configure the dmz,

what do you call "wan" ?

(in the sophos, there is 2 Ips : one for the lan (port1) and one for the wan (port2))

so in the sophos, what do I put in the wan ?

and in my dsl router, what do I put in the dmz ?

Daniel,

You router should have wan, LAN and dmz.

Each interface uses a different ip.

Can you share a small network diagram?

Thanks