Sophos Firewall Blocking Page

Hi Kramnai,

Thank you for reaching out to Sophos Community.

Kindly check the following configuration via PROTECT>WEB>User Notification>Message for Block Action

Also, see below post for additional reference

 Customizing Block Message for Web 

Hi Erick, 

Thank you for your reply! I have already enabled the "Message for block" action, but it is still using the "Access Blocked: Policy Block" message (as seen in the image).

I also tried it on different browsers, but the result remains the same.

Here is my settings;

The block page that you are seeing is not generated by the Sophos Firewall.  Do you have an endpoint solution or something else that is also doing blocking, that is perhaps blocking earlier?

Try this:  Make sure you can go to a website (eg poker.com).  Then change your web policy to block Gambling.  Now go there.  Do you get the correct block page?

The block page that you are seeing is not generated by the Sophos Firewall.  Do you have an endpoint solution or something else that is also doing blocking, that is perhaps blocking earlier?

Try this:  Make sure you can go to a website (eg poker.com).  Then change your web policy to block Gambling.  Now go there.  Do you get the correct block page?

Thank you for your reply. I do not have any other security device that might be causing the block. While I have Bitdefender installed, URL filtering is not enabled on my PC. My office laptop uses S1, and both devices are showing the same blocking page, even on a freshly created Windows VM running on Proxmox with no antivirus installed. I’ve also tried your advice, but the block page still does not appear.

For the HTTPS sites, the certificate would need to be created for the block and signed by a CA.  Can you look at the certificate signer and see who it is signed by?

The blocked page is signed by Sophos SSL. Please see the image below.

Found the page, it is a fallback in DPI mode.


Can you go to Administration, Admin and User settings > Admin console and end user interaction
When redirecting users...

By default it should be "Use the IP address of the first internal interface" and that is has the IP of the first LAN port.

What do you have on the page (screenshot).  Can you change it to the configured hostname (assuming the client can DNS resolve the hostname).