User Interface Designer

Hello there,

Thank you for contacting the Sophos Community.

What part doesn't make sense for you, or what/how are you expecting to see?

The Interfaces connected to your devices will show on TOP, below any Unbound interface following the closest interface number to the latest connected interface.

Regards,

They mean that ports 10, 11 and 12 should come at the end of the list, not after port1. Obviously an issue from sorting alphabetically.

They are correct but I can probably come up with 100 things I'd like to see improved first ;)

Hello JasP,

Then you would be fine with:

1,10,2,3,4,11,12?

but not 

1,10,11,12,2,3,4?

For me, it makes more sense to follow with the highest number first.

I will pass down the feedback for this though.

Thank you,

Regards,

Well this is really Fermin 's post but personally I was taught at school that it goes "1,2,3,4...10,11,12" ;)

yes, the order should be
1, 2, 3, 4, 5, 6 .... 10, 11, 12

and a, b, c, d .... non-case sensitive

Hello,

So if Port1 and Port 12 are used, but 2 and 11 aren’t, do you want to see a whole number of empty unbound ports going from 2 to 11? Rather than seeing the ports you actually use listed on top from lower to higher?

Regards,

Well at the moment it does neither. It takes no account if the port is bound but lists them in strictly alphabetical order (used or not). I personally think it would be a bit confusing if it moved the unused ports down but that is just me. It would be nice if they were in logical order though (1, 2, 3, 4, 5, 6 .... 10, 11, 12).

Well at the moment it does neither. It takes no account if the port is bound but lists them in strictly alphabetical order (used or not). I personally think it would be a bit confusing if it moved the unused ports down but that is just me. It would be nice if they were in logical order though (1, 2, 3, 4, 5, 6 .... 10, 11, 12).