Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 9 replies
  • Answers 1 answer
  • Subscribers 38 subscribers
  • Views 4154 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ROS Sophos

IT 2

Hi, 

I'm new with this equipments, i'm trying to configure VLANS between two equipments (SOPHOS -» Switch)

SOPHOS:

- WAN - DHCP from ISP router

- LAN PORT1

IP: 192.168.100.1/24 - ZONE LAN

1.10 - VLAN 10 - 192.168.10.1/24 - PORT 1 - ZONE LAN

1.20 - VLAN 20 - 192.168.20.1/24 - PORT 1 - ZONE LAN

Have DHCP configured for the physical port and each vlan.

The firewall is configured to allow any traffic for ZONE LAN

On the switch side:

Configured port 8 (connected to sophos PORT1) as trunk tagged

port 1 as vlan 10 untagged

port 2 as vlan 20 untagged

I cant get DHCP on the switchports 1 and 2 but if i configure manually ip address on the computers NIC i can ping the vlan respective vlan gateway (ex: 192.168.10.1) and have access the internet.

I'm missing any configuration as i'm using router on a stick?



This thread was automatically locked due to age.
Parents Reply Children
  • +1 in reply to rfcat_vk

    Hi,

    Yes i do. Both switchports (port 1 - vlan 10 and port 2 - vlan 20) have the same issue, work with the respective vlan only if i set manual ips on the computers nic. I cant get dhcp for that ports/vlans.

    The other ports arent in use.

    Edit: on the firewall side i dont see any option to tag the vlan. I have the VID so im assuming the firewall is doing it by default

  • 0 in reply to IT 2

    Hi,

    the XG creates the VID when you create your VLANs. Does your switch support L3 VLANs, though this shouldn't be an issue with v19.x and you do not need an addressor the physical port.

    Ian

    XG115W - v20 GA - Home

    XG on VM 8 - v20 GA

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk

    Hi,

    My switch is an aruban instant on 1930 8port JL680A.

    For this configuration is requires l3?

Unfiltered HTML