XG210 (SFOS 19.0.1 MR-1-Build365)
Hello,
I have to create a lot of static routes and would like to do this via SSH.
When I create a static route via "ip route add 10.xxx.xxx.xxx/24 via 10.xxx.xxx.xxx" it is clearly visible in the overview "route -n" BUT not visible via GUI.
I can create the same route again within GUI and it will not say "route already exist"
When I create a static route in the GUI in the first place I can see it directly within shell.
Question: Does it take some time to show the routes (that I created within the shell) in the GUI?
Regards
Janek
This thread was automatically locked due to age.