RX State: packets Drop and error

Question

The following is the error in firewall log which showing RX State: packets errors:8 dropped:58662, please help to solve this issue. 
 port 1 
 UP BROADCAST RUNNING MULTICAST RX State: packets:169291044 bytes:41103398907 (38.2 GiB) errors:8 dropped:58662 overruns:0 frame:0 TX State: packets:205826810 bytes:246910723588 (229.9 GiB) errors:0 dropped:0 overruns:0 carrier:0

Vivek Jagad · Accepted Answer

But raja the improvement here is the errors are not increasing after connecting to the laptop. errors:1063
You can fire the command again and again and the errors should not increase.

That also concludes the issue is with the switch !!

raja · Answer

Thank you so much Vivek. We have replaced the switch and it is working fine.

Vivek Jagad · Answer

Hello raja , Thank you for reaching out to the community, you can check the following things below: > Login in to the putty via admin credentials and press 4 for the device console: 1.) type the following command: console> system diagnostics utilities bandwidth-monitor and then press 'u' twice if you see the errors/sec on that Interface Port1 try changing the negotiation from the network > interface > advance settings and see if that errors becomes zero on the bandwidth monitor. 2.) Now from the advance shell: press 5 for the device management and then press 3 for the advance shell type the following command to test the interface: # ethtool -t Port1 interface might fluctuate for few seconds but that you'll have the results in front of you if the test failed or pass. Other than this 2 options mentioned try changing the cable and Port on the peer appliance [switch it connects to]

RX State: packets Drop and error

Top Replies