Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 8 replies
  • Answers 1 answer
  • Subscribers 41 subscribers
  • Views 4973 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Change Interface Zone before Initial Setup via CLI

n33dfull

Hi,

i need to change the Sophos Interface Zone before Initial Setup of Firewall, because i only can access Port2 (WAN).

Actual: 

Port1 LAN - 172.16.16.16
Port2 WAN - 10.128.0.5

Windows Machine to Configure is in the WAN Network 10.128.0.2

I already tried searching for a config file, where i can change the Interface Zone manually and i also done this: 

Console: 

4. Console 

system appliance_access enable 

Then I'm able to access the userportal buut not the WebAdmin or Initialsetup.

Regards



This thread was automatically locked due to age.
Parents Reply
  • 0 in reply to rfcat_vk

    Hi
    Software Installer, VM, 2 NICs but Port1 is Inaccessible.

    I wan´t to configure the FW on Port 2, later I'm able to access Port1 as WAN port. 

    Port1 could be accessible with following config (but I`m not able to set the IP with Default GW):

    IP: Public IPv4

    SM: 255.255.255.255

    GW: 10.255.255.1


    Regards

Children
Unfiltered HTML