This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

HA Peer does not start

Hey there,

I´ve set up a Sophos XG cluster with 2 Sophos VMs. After the init the peer VM restarted but never came up. At a look at the console I saw this:

A simple restart of the VM doesn´t change anything. How can I fix that? A memory and disk test through the troubleshoot menu ditn´t display any errors.

Thanks!

This thread was automatically locked due to age.

0 EinMarco_DE over 3 years ago

Hey there,

I have tried to reinstall the peer VM.

- Disabled HA on the master

- Installed the peer VM plain from ISO

- Set up basic configuration (Peer IP, HA Interface)

- Init the HA from the master

After the init the peer VM restarted (no problems, SFOS came up), two minutes later the peer restarted again an stuck in the same like above.
Cancel
Vote Up 0 Vote Down

Cancel
0 LuCar Toni over 3 years ago in reply to EinMarco_DE

Did you check the Option for virtual appliances in the HA Config menu?

__________________________________________________________________________________________________________________
Cancel
Vote Up 0 Vote Down

Cancel
0 EinMarco_DE over 3 years ago in reply to LuCar Toni

Of corse I have enabled the option "Use host or hypervisor-assigned MAC address" and "Fail back to primary device after it recovers" because the hypervisor doesn´t allow MAC-spoofing.
Cancel
Vote Up 0 Vote Down

Cancel