This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Upgrade to 18.5.1 mr-1 now failsafe mode...

My appliance is intel box 4core 4gb ram 7 nics 128gb ssd

18.0.5 586 works fine i can revert back and all is good.

when i did the firmware upgrade to 18.5.1 mr1 it loads into failsafe mode with the reason "Unable to setup dpdk environment" not sure what that means.

so i pulled the drive and used my identical spare i have for testing and did a fresh install of 18.5.1 same issue...

sometimes it does load into "normal" mode but then when i press "1" for network setup it indefinitely says "please try after some time system initializing" and the network will never load.

for my own sanity i did a fresh install of 18.0.5 586 on this test drive and it boots up no problem super fast

I guess my ask is how to fix... failsafe mode with the reason "Unable to setup dpdk environment"?

This is my first post here so if more info needed let me know.

ps this device i am using is a bit older (core2 quad q9400, ddr2 ram) not sure if that matters but it does work with 18.0.5 no issues



This thread was automatically locked due to age.
Parents Reply Children
No Data