Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 11 replies
  • Answers 1 answer
  • Subscribers 41 subscribers
  • Views 2996 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XG installation issue on Intel NUC Compute Element

Walter Kunkel

Hi All,

EVen though I have a perfectly running XG running as a VM in VMware, I want to move it to hardware.  As a result I purchased an Intel NUC compute element, including a chassis with two NIC's.  From a hardware perspective it therefore has the requisite CPU, Ram (4GB) and storage (64GB) and 2 NIC's.

Writing the ISO to a USB stick with Rufus (DD mode) works perfectly as does the installation, were it gets to the point where the installer states "Remove the installer disk and press y to reboot".

This is where the problem starts.  The device goes through POST, displays "Booting '18_5_1_326'", and after about 3 seconds resets and restarts POST.

I have disabled and re-enabled Serial ports in the BIOS, making no difference.

Where should I look next?

Thanks,

W



This thread was automatically locked due to age.
Unfiltered HTML