Hi All,
EVen though I have a perfectly running XG running as a VM in VMware, I want to move it to hardware. As a result I purchased an Intel NUC compute element, including a chassis with two NIC's. From a hardware perspective it therefore has the requisite CPU, Ram (4GB) and storage (64GB) and 2 NIC's.
Writing the ISO to a USB stick with Rufus (DD mode) works perfectly as does the installation, were it gets to the point where the installer states "Remove the installer disk and press y to reboot".
This is where the problem starts. The device goes through POST, displays "Booting '18_5_1_326'", and after about 3 seconds resets and restarts POST.
I have disabled and re-enabled Serial ports in the BIOS, making no difference.
Where should I look next?
Thanks,
W
This thread was automatically locked due to age.
