This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem adding a network on ssl vpn

Hi,

we have a firewall running on the latest release V18 MR-5.

We use split-tunnel. When adding a new network to the SSL-VPN connection then the new route is not set on the client when disconnecting and logging in again.

Everything is running as expected when the remote user is setting the route manually for the ip address assigned by ssl-vpn. So all other configurations on the network and traversed firewalls seem to be correct. 

1) At sophos SG I am quite sure that adding a new network disconnects all clients. Isn't this also the case on XG (normally)? I am asking this because the clients are not disconnected in our case (when adding the new network).

2) Is there a known issue regarding this?

3) Are there any limitations (for example the number of networks for a split tunnel)?

4) We haven't tried to restart the OpenVpn service as this will disconnect the other users. How can it be started anyway without restarting the whole firewall cluster?
I do not find it under system services - services.

5) Where/how can i actually verify whether the new network is written to the configuration that is pushed out to the client? The client logfile doesn't show any sign of the added network.

Regards,
BeEf



This thread was automatically locked due to age.