Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 7 replies
  • Subscribers 38 subscribers
  • Views 3272 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

PPPOE config on Fritzbox and Sophos XG

Chicho

Hi all

I want to configure my Fritzbox 7590 as a modem, i did it like this for havin my Public IP on my Sophos XG, i tried like this:
https://emil.network/netzwerk/fritzbox-als-modem-nutzen/ My fritzbox Config:

But I also tried this one:
https://deer-it.de/fritzbox-7412-modem-bridge-mode-pppoe-passthrough/

My Sophos config looks like this:
the credentials (username & password) are those for the Router, right?

i read that the public ip should be recognized automatically but
i also tried to set the public ip on the field "preferred IP" but still no connections from the other ports of the firewall.

If you dont have a solution may also troubleshooting steps would help to find the solution ;)

thanks in advance!



This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to LuCar Toni

    Thank you for your reply Toni

    i did found the credentials for my Online Account for the Sunrise Portal - i tried it with them but same..

    Still no public IP on this port Disappointed  and no internet connection from the other ports, i tried the config of my post and this one:

    FYI: The connection from other ports couldnt be the problem because i did give the WAN port a fixe ip from fritzbox which allows the internet connection also from the other ports with the any to any rule.

    how you think can i troubleshoot in this case?

  • 0 in reply to Chicho

    Check if the Provider use VLAN or not (VDSL). And check why the PPPOE interface is unplugged. 

    __________________________________________________________________________________________________________________

  • 0 in reply to LuCar Toni

    i have receive firstly the false login data this is why it couldnt connect.

    it now says "connecting"

    does it take some time till it finds the connection?

    its still the same config as my first post.

    Thank you for your help Toni

  • FormerMember
    0 FormerMember in reply to Chicho

    Hi ,

    Assuming Fritzbox is currently configured in bridge mode.

    Check PPPoE events for interface Port2 under Log viewer > System, apply filter with 'PPPoE'

    You can also check packet flow in CLI by following the below steps.

    ==> Login to SSH > 4. Device Console

    console> tcpdump interface Port2 -e

    Please share session output & log viewer snapshot here or in PM.

  • 0 in reply to FormerMember

    Dear Yash

    Thank you in advance, i apreciate it. This is the UI output:

  • FormerMember
    +1 FormerMember in reply to Chicho

    As per the log events, XG has sent a discovery request(PADR) packet, but there’s no session confirmation(PADS) packet coming from the PPPoE server.

    PADR: PPPoE Active Discovery Request

    PADS: PPPoE Active Discovery Session-confirmation

    ==> Here is a sample snapshot to understand PPPoE packet flow.

Unfiltered HTML