18.0.5_MR5-586: HA (A-P) no access to primary node after QuickHA

Question

Hello, 
 
 I installed two boxes with 18.0.5_MR5-586 and Initiated after License Sync (only the primary one) Quick HA on both nodes. 
 After some while, the HA Mode is enabled.

But after that I lost access to the primary Node. This Node is no more pingable. The Aux-Node is Up & running. 
 What's going on there? 
 How can I enable access to the primary node? 
 
 Guenter

LuCar Toni · Answer

Assuming you are using a virtual setup, do you have MAC Spoofing disabled? Because XG will load virtual MACs and those are likely to be blocked by the virtual switch. 
 You can check the configuration "Use physical Interfaces instead" within the HA Mode, after setting up the Cluster.

18.0.5_MR5-586: HA (A-P) no access to primary node after QuickHA

Top Replies