This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem between RED and XG - transmission of the voice

Hello,

we have a problem with the transmission of the voice on our IP telephones between the XG and the SD-RED 20.

The connection can be established (it rings and you can pick up the receiver), but nothing can be heard.

The RED is located in the network 192.168.150.0/24

The XG in the network 192.168.130.0/24.

The telephone system has the 192.168.130.251.

Otherwise all traffic between the XG and the RED works.

Do any routes have to be set here in addition to the firewall roles?

Thank you very much and best regards ...

Martin



This thread was automatically locked due to age.
Parents Reply Children
  • Hi there,

    I just installed a RED device yesterday for a client, the scenario you described above was exactly the same issue I had.  The RED network could communicate with the client's PBX, I could ping the PBX, the phone would register & ring but no audio.

    in my case...  After some diag's and packet sniffing, the issue wasn't with the RED/XG, it was the PBX.  I had to enter in the subnet of the RED device as an internal network in the PBX config.

    Just a thought...  could be same issue.  Check your PBX.

    In my case this client uses a FortiVoice PBX, and this setting was under Phone System - Advanced Settings - SIP - Advanced Setting - Internal Network.

    André

  • Hello,

    unfortunately this is not the same problem. I can make calls between the RED and the XG without any problems. The VPN clients can also call the clients behind the XG.

    But I cannot make calls between the VPN clients and the RED clients.

    That's my problem. But thanks for the help.

    Martin

  • FormerMember
    +1 FormerMember in reply to Admin TSK

    Hi ,

    Do you have RED to VPN and VPN to RED firewall rules configured?

    If you're not using Sophos Connect with a default gateway, then please ensure that RED networks(192.168.140.0/24, 192.168.150.0/24) are added under 'Permitted network resources' in IPsec (remote access) configuration.

    If these settings are already done, then I'd suggest opening a support case to get it investigated further. Also please share the case ID via PM.

  • Hello,

    now it finally worked. The RED is missing in the VPN settings as 'Permitted network resources' Thank you for your support ...

    Martin

  • FormerMember
    0 FormerMember in reply to Admin TSK

    Glad to know that an issue has been resolved.