Dear comminity,
is there any chance to configure interfaces via console?
I've done an Sophos Migration Assistant restore on a new XG430 release SFOS 18.0.4 MR-4 and when the XG430 booted it configure the interface as PortA1, PortA2, PortA3, ecc. but in the new hardware i don't have the interface expantion module A.
I've now only access by cli to XG430 and i see the interface Port1, Port2, Port3 ecc by the command:
console> show network interfaces
Port1 Zonetype:UNBOUND MAC Address:C8:4F:86:09:35:AC MTU:1500
Speed:65535Mb/s Full Duplex Auto Negotiation:yes
BROADCAST MULTICAST
RX State: packets:0 bytes:0 (0.0 B)
errors:0 dropped:0 overruns:0 frame:0
TX State: packets:0 bytes:0 (0.0 B)
errors:0 dropped:0 overruns:0 carrier:0
Port10 Zonetype:UNBOUND MAC Address:C8:4F:86:09:35:B5 MTU:1500
Speed:65535Mb/s Full Duplex
BROADCAST MULTICAST
RX State: packets:0 bytes:0 (0.0 B)
errors:0 dropped:0 overruns:0 frame:0
TX State: packets:0 bytes:0 (0.0 B)
errors:0 dropped:0 overruns:0 carrier:0
Port2 Zonetype:UNBOUND MAC Address:C8:4F:86:09:35:AD MTU:1500
Speed:65535Mb/s Full Duplex Auto Negotiation:yes
BROADCAST MULTICAST
RX State: packets:0 bytes:0 (0.0 B)
errors:0 dropped:0 overruns:0 frame:0
TX State: packets:0 bytes:0 (0.0 B)
errors:0 dropped:0 overruns:0 carrier:0
But If I try to configure the ports by the interaction menu:
1. Network Configuration
1. Interface Configuration
I see only the interface named PortA1, PortA2, PortA3, ecc..
Network configuration Menu
1. Interface Configuration
2. DNS Configuration
0. Exit
Select Menu Number [0-2]: 1
Sophos Firmware Version SFOS 18.0.4 MR-4
Network Settings
Interface Name : PortA1 (Physical)
Zone Name : WAN
Then I can't connect on it by web gui.
Thank you
This thread was automatically locked due to age.