Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

XG Firewall-Force Web Browsing To Use Specific WAN Link?

Hello:

We have an XG210 firewall that has three WAN links.

Link 1: Sprint (50 Mbps)

Link 2: Comcast (125 Mbps)

Link 3: AT&T (50 Mbps)

Links 1 and 2 are in the active/active state with load balancing and Link 3 is set for failover.

I would like to force all outbound web browsing thru Link 2 (Comcast). How can I do this?

Thank you.



This thread was automatically locked due to age.
Parents
  • FormerMember
    0 FormerMember

    Hi ,

    Thank you for reaching out to the Community! 

    You could configure the SD-WAN policy route to route all the internet traffic through the link2.

    Go to Routing > SD-WAN policy routing. Scroll down to IPv4 or IPv6 SD-WAN policy route and select Add

    Add a rule name > Select the internal inbound interface > Select the HTTP/HTTPS service, and in the routing, select link 2 as a primary gateway. If you like to configure the failover interface, you can configure it as a backup gateway. 

    Sample screenshots: 

    For more info, check out the following document: 

    Thanks,

Reply
  • FormerMember
    0 FormerMember

    Hi ,

    Thank you for reaching out to the Community! 

    You could configure the SD-WAN policy route to route all the internet traffic through the link2.

    Go to Routing > SD-WAN policy routing. Scroll down to IPv4 or IPv6 SD-WAN policy route and select Add

    Add a rule name > Select the internal inbound interface > Select the HTTP/HTTPS service, and in the routing, select link 2 as a primary gateway. If you like to configure the failover interface, you can configure it as a backup gateway. 

    Sample screenshots: 

    For more info, check out the following document: 

    Thanks,

Children