This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to use VLAN Interfaces in XG

Hi,

until now I used XG as virtual machines.

so adding a new VLAN was to add an network interface at VMware/Hyper-V, set a VLAN tag on VMware/Hyper-V and use a new interface.

In appliance there are limitations because of the physical interfaces within the XG.

So I understood, that you add a VLAN Interface on the corresponding physical interface (IP of the physical interface is needed but not used), configure a VLAN tag on the switch/router and the rest of the network and go ahead. but no success.

Also described here: community.sophos.com/.../123127

 

Config is like this:

XG 210 Port 5: IP 1.2.3.4/255.255.255.255 (must be configured but is not used - is this right?).

VLAN Interface on Port 5: I: 192.168.10.2/24, VLAN 34

VLAN Tag set on Switch and all other devices.

 

Any ideas?



This thread was automatically locked due to age.