This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

BUG? Can't change Device Access Settings

Hi!

We are migrating from UTM to XG using the migration tool. We generated the config and imported it into our spare SG.

We are now seeing an error when editing the local Service ACL in "Administration -> Device Access". We edited it before, but for some reason it now gives the error you can see below. I ommited the checkboxes for security reasons. The error comes up if we try to change any of the several checkboxes there.

Any ideas on why this is happening and how to solve it?
Thanks!

This thread was automatically locked due to age.

Parents

0 errollm over 5 years ago

Any new info on this issue? I'm having the same problem after I used migration assistant to convert my SG210 configuration to XG230. I can't change any of the Device access settings. It errors out and refreshes.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 errollm over 5 years ago

Any new info on this issue? I'm having the same problem after I used migration assistant to convert my SG210 configuration to XG230. I can't change any of the Device access settings. It errors out and refreshes.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 errollm over 5 years ago in reply to errollm

Update - I was able to change the Device Access information if I edit the Zone in Network | Zones, so achieved my initial goal of enabling HTTPS management on the WAN interface, but it would seem there is a bug related to the Device Access matrix when configuration is converted using Migration Assistant.
Cancel
Vote Up 0 Vote Down

Cancel